Categories

• - Check Valve Flapper Type
• - Check Valve Lift Type
• - Check Valve Piston Type
• - Check Valve Spring Type
• - Flap Type Check Valve
• - Lift Type Check Valve
• - Piston Type Check Valve
• - Concrete Slabs For Sale
• - Type 304 Stainless Steel

FAQ

I have mitral valve prolapse. Just recently Ive been getting chest pains more often * few times a day* and the panic and anxiety have gotten worse. I had a pain last night that lasted about 10 minutes and it was very uncomfortable.I know mitral valve prolapse is a condition that usually not a threat. But can it get worse over time with some people?My doctor already knows I have it but should I go back to have more tests done?Im kinda scared because my symptoms are getting to be more than what they were.Any advice?

It's not clear whether or not your symptoms are pathological and you are anxious and worry...

I have a 1993 Jeep Grand Cherokee 5.2L V8 I posted a question on here before and many thanks, What I had was a bent rod well I took off the head and removed all the valve springs and found that where the bent rod was the valve stems are bent too. What else do I need to do? or can I clean the head up make sure no valve holes are bent, replace the rods and valves and be good to go. I want my jeep running again!!! Thanks

Valve stems don't usually bend unless the valve hits a piston. I am assuming the rod that ...

i am wanting to know if there is a diagram of the engine or at least if you have to remove the intake manifold to get to the egr valve.

the accord is one of the best engineered cars that honda has ever produced and if the one ...

I replaced the valve cover seal and I wanted to know the torque specs for the valve cover bolts and the sequence it should go

Valve covers require minimal torque and usually, it's best to err on the side of less torq...

I have a 3-circuit sprinkler system in my yard (built by me, last year). I discovered this week that I overtightened the connection between the valves and the downstream pipes, and 2 of the three valves are cracked, and leaking, at the connection. I replaced all 3 valves, and now I need to reconnect them to the supply. But this means I'm working backward - when I bult the system last year, I worked downstream - I built the manifold first, connected the valves, then the remainder of each branch. Now, I have to make the new manifold fit the valves, and naturally, they don't line up perfectly. Any tips/tricks on connecting valves in this situation? Is there such a thing as flexible pipe that can withstand continuous pressure? I'm using unions at both ends of each valve to help things go together/come apart more easily.

valve manifolds are something that requires practice and experience. i used to struggle wi...