Submersible Chemical Pump

Hot Products

FAQ

Volkswagen Polo pump for heating lamp and light machine
Oil lamp light generally has the following reasons: 1, oil pressure is not normal; 2, oil pressure induction plug failure; 3, related lines, bad contact, fault, etc.. Suggest going to the service station to have a check.
How to judge the Audi a6l2.0t oil pump broken?
If not removed, the amount of oil on the car, low oil pressure on the problem, if removed, go round to see how the pumping effect
The oil pump is greased by hand, so why not oil it on the truck?
This has many aspects: the oil circuit is blocked, the oil pump pressure is not enough, the loading seal is not installed
What is the influence of insufficient oil supply in the oil pump?
Increase the load on the engine and damage the engine
The oil pump is not working well. What about the engine?
The oil pump is not working well and affects the lubrication effect of the car. It is several thousand revolutions per minute. The piston ring oil ring and cylinder wall friction, so long, not only prone to the engine temperature is too high, and may cause the wear of piston ring or the cylinder wall, if the result of wear is more trouble, there will be cylinderscoring phenomenon resulting in piston ring and the cylinder wall gap is too large, the oil into the cylinder, is what we say oil burning, automobile exhaust is not normal, a row of black smoke, causing the engine power shortage or repair as soon as possible.
What about the oil leakage of automobile oil pump?
Oil leakage of automobile oil pump? You're talking about pressure relief, right? Usually the valve is out of order!
The car broke down and the maintenance crew thought it was a mechanical filter, but changed 4 machines, or did they leak oil?. Then he said it was caused by the high pressure of the oil pump. Replacement pump, heroes, help me. Is the pressure of the oil pump too high to cause oil leakage on the engine?
Is the pressure lamp alarming or something wrong?Generally, stress doesn't come up. That must be the problem of the oil pump. Or the shaft is broken. Either inside the mine, there's no pressure.Oil itself is used more and more concentrated.
Is the engine speed the same as the pump speed?
No. the speed ratio between the engine and the oil pump is 2:1. That is to say, when the engine rotates, the two turns of the pump rotate. The principle is that the engine completes the intake, compression, work, exhaust, the four useful hours to rotate two times. The oil pump works only when it is done. So, just one lap would do.