Q:The oil pump is not working well. What about the engine?

Engine lubrication is not enough, it may damage the engine cylinder caused by high temperature

Q:How do I check if the oil pump is working properly?

Oil pump directly linked engine, engine transfer pump is also transferred, the work is normal to see the pressure, the pressure is insufficient, the oil lamp will light, will alarm.

Q:Single cylinder diesel engine crank bearing lock replacement, cause oil pump wear, replacement. What's the reason for the lack of power after the change?

Is the cylinder piston because the crankshaft is also affected by tile, cylinder piston also pulled, so underpowered

Q:474 new engine replacement and pump axle

Detection of oil channel have blocked, remove the oil pan, thrust washer third Daowagai above, if excessive wear

Q:TOYOTA Camry oil pump how to change?

You need to open the pump for the rear seats in the rear seats below a small screwdriver with a screw removed, it will be able to see the tank, then the tank above the lid to loose direction, until the lid up, it will be able to take out a pound of oil.

Q:What's the reason that I changed the new oil pump instead of the engine oil?

When you switch the pump oil pump to oil or oil is that gambling is dead

Q:How do I see the motorcycle's oil pump is broken? Two red

Look at the smoke in the muffler knew no oil pump is not good.

Q:Reasons for heating of oil pump in roadheader

If you are using a high temperature oil pump motor may be caused by the following reasons: first, check whether the pump because of overload caused by fever; test method: with a twist of the hand to see if high temperature pump connector flexible operation, such as flexible and can be excluded: Two: check to see how the materials proportion is too large. If too much can cause motor overheating; Troubleshooting: re selection; three: when the working pressure is too large can cause motor overheating and Troubleshooting: can try to use high gear pump should be able to solve the problem of pressure; four: use range (flow head) over high temperature oil pump design requirements? Choose the right motor according to the serial type. Five: high temperature oil pump motor assembly and coaxial pump motor will not only of fever and noise during use will increase, solution: open angle screw, re check coaxiality, and then tighten the screws can be solved;

Q:What parts of motorcycle oil pump are connected with them?

It is connected with the engine crankshaft by the helical gear, turbine spiral rod combination, small chain and so on, and works simultaneously with the engine crankshaft

Q:The carbon pump is blocked, the Walla fell, the total amount of money to clean the engine?

If the tile is gone, cleaning is no use