Charcoal Air Filter System

Hot Products

Zirconia Foam Ceramic Foam Filter

Alumina Wear Resistant Tile

Cordierite Ceramic Plate For Sale

Insulation Flexible Mica Paper Roll

Ceramic Filter Plate 3

Ceramic Filter Plate 1

Ceramic Filter Plate 4

Fiberglass Cloth Welding Blanket

Silicon Carbide Ceramic Foam Filters Lower Price

Ceramic Foam Filter For Foundry

FAQ

How can I avoid the backwash pressure in the production of ceramic filter?

The backwashing system of ceramic filter is usually made up of water inlet, water inlet, pressure gauge, water filter and filtered water pressure gauge, and then connected to the inside of ceramic filter. Such as the discovery of ceramic filter recoil pressure became smaller or even no recoil pressure, you can carefully observe the surface of the ceramic filter plate is wet or ceramic filter plate wear without water injection at the discharge point, investigation and the reasons for the following aspects:Is the water inlet pressure or normal?How about the sealing performance of the water filter? Does the filter element need to be replaced?Is the recoil system piping (metal pipe, ceramic filter plate, connecting pipe, etc.) broken, leaking or dripping?Is the distributor valve properly installed and is it worn?Are there any cracks in the ceramic filter plate?Is the pressure gauge broken?The most likely reason is 1, 2, two, the best water should not be too dirty, filter should be replaced regularly. I hope the answer can help you.

Does the ceramic factory use hydrochloric acid?

For the use of a long time, the method 1, the effect is still no significant improvement, that is how to plug the ceramic filter plate regeneration? The ceramic filter plate with uneven or non sucking slurry can be removed, and oxalic acid or other acid liquid with certain concentration and certain temperature can be taken together to dredge the microporous of the ceramic filter plate. (do not recommend sulphuric acid)

The efficiency of ceramic filter is low. What's wrong with it?

Ceramic filter is a new and efficient dehydration equipment. If users find the ceramic filter board surface suction effect is poor, or even do not suck slurry, we should promptly investigate the causes, so as not to affect production efficiency.

What about the leakage of the ceramic filter static and dynamic sealing points?

When the main shaft is rotated, the filter cake is adsorbed on the surface of the ceramic filter plate and dehydrated by the vacuum generated by the vacuum pump.

The ultrasonic wave of ceramic filter is not good. What's going on?

In ancient China, filtration technology was applied to produce paper made from plant fibers in 200 bc. The paper method was improved in AD 105. He wandered in dense in papermaking during plant fiber pulp fine bamboo. Water curtain gap filtration, a thin layer of wet pulp stay on the bamboo surface, after drying into paper.

What is the reason that ceramic filter does not absorb mineral powder?

One is leakage, two is no liquid output or output weakness, pressure is too low, cleaning effect is not good, the pressure is too large, will cause damage to the filter plate and reduce the slurry concentration. The recoil pressure is regulated by the pump loop valve and the pressure regulating valve.

Principle of chemical engineering drum vacuum filter, the faster the speed, the less the amount of filtrate obtained per turn, the more the amount of filtrate obtained per unit time?

The faster the speed is, the shorter the time required for each turn, i.e., the shorter the filtration time, the less the filtrate will be

Ceramic filter ceramic plate blockage, productivity reduction, how to clean, to achieve the best effect cleaning problems

Replace ceramic filter plate:Different users because of pulp particle size and different characteristics, the service life is long and short of ceramic filtering plate. For the use of a long time and after the method 1 and 2, the effect of slurry suction is still very poor, we should consider replacing the new ceramic filter board.