Ac & Heating

Hot Products

FAQ

Composition of solar heating composition
Solar heating equipment, the main components: solar collectors (flat solar collectors, all-glass vacuum tube solar collectors, heat pipe solar collectors, U-tube solar collectors, etc.), storage tanks, control systems, Pipe fittings and related accessories, building the end of the cooling equipment and other components.
Can electric heating boilers and coal-fired boilers be able to share together?
As if not, have not seen these two strings with the use
The water in the heating furnace is often good
To see where the water quality, water alkali is not easy to change the water, the total water, water jacket furnace will scale, the flow is not smooth, natural heating effect is not good, coal (fuel). Look at the water is not high alkali method is very simple, look at their own home or someone else's home, aluminum water bottle, the scale of the number of more than easy to change the water, if it is factory, on the point of water treatment equipment, home In the water salt, I do not know what kind of heating furnace, if it is the soil of the tube of the circle, nothing to add, and winter with hot water no need to add things.
Which man knows the construction of temporary heating program, please tell me ah! Thank you!
Try to avoid coal heating, you can use some safe electrical heating equipment, such as: air conditioning, silicon hot oil heater, electric heater, solar fan, etc.
To warm the system main material and auxiliary materials which include what
The system has a large number of main parts: boiler, main channel, sub-catchment, coil, thermostat. Accessories: insulation, staples, insulation board, reflective film, PE moisture film, elbow sets, and so on
What are the advantages and disadvantages of warming? What kind of heating should be better choice? More
Advantages of the above said, I talk about the shortcomings of warming, warming slowly, taking up the layers of high.
To install the mixed water center also installed with a pressure differential bypass valve
The role of mixed water center is mainly to adjust the warm water supply problems, to achieve automatic control of water supply temperature. Reason: According to the provisions of the country to warm the installation, the water temperature should not be higher than 60 ℃: 1, to prevent the warm water in the warm pipe, water mixers and other heating system components in the scale. 2, to warm the pipe material for the plastic material, the higher the temperature of the working environment, the greater the pressure, will shorten the warm life. Municipal central heating more in accordance with the heating film heating temperature of 80 ℃ to the water, far more than the warm to apply the highest temperature. The mixed water center can mix the low temperature water of the heating system backwater into the water supply pipe, lower the heating water temperature, and then supply it to the floor. Refer to the following figure: Madison fireplace, dedicated to your service.
Gas boiler hanging water valve bad, how to pay the furnace.
After the wall valve has been damaged, it is best to replace a model with the same parts, once and for all, to facilitate future use and maintenance. If you do not find the same parts, and the water valve is only damaged, and not leaking, and not to the tap water back, you can use y the following way to fill: 1, the heating system to remove the remaining pressure (through the exhaust valve ), And then open any pipe at a connection, connect a three-way, so that the ends of the tee connected with the original connection, more than one end of the connection of a pipe and a valve, the valve and tap water can be connected The 2, open the valve, open the water valve, tap water into the heating system, observe the pressure gauge, to 1.5bar when the valve closed, remove the water pipe. You can use the boiler. 3, if the tap water pressure is too low, less than the minimum value of the start of the boiler, single Dan Wei Pie Pie Shi paint ten ginger can be manually pressed pump connected just the valve, manual pressure to 1.5bar.