Water Pumps Cheap Centrifugal Good Quality Made In China

Ref Price:
Loading Port:
Tianjin
Payment Terms:
TT OR LC
Min Order Qty:
1 set
Supply Capability:
100 set/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

1.Specifications

1)High performance
2)Mechanical seal
3)Cast iron impeller or bronze impeller
4)Lower vibration water pump
5)Large flow

2.Packaging & Delivery

Packaging Detail:

export wooden cases

Delivery Detail:

within 30 days once receipt of 30% T/T prepayment

BPO Irrigation Centrifugal Split Water Pump

3.FEATURES

BPO series single-stage double-suction open type centrifugal pump self-researched by the Company after absorbed advanced technology of similar products and combined application requirement of various customers. The series pump adopts excellent hydraulic model, wider type spectrum and better structure. Pump casing is produced by special machine tool, which ensures concentricity among shaft bearing, shaft and pump case, and provides better reliability and maintainability. Apply to municipal water supply and drainage, water circulation of air conditioner, agricultural hydraulic engineering, such as irrigation, drain flooded fields etc., industrial water supply system, firefighting system, water supply and drainage of
heating system, transportation of clean water

4. OPERATING CONDITION

a)Rotate speed: 2950r/min, 1480 r/min, 980 r/min, 730 r/min
b)Flow range: 64.4~9810m3/h
c)Delivery lift: =200m
d)Medium temperature: =80 ,
e)product adopting special materials: -20 ~120
f)Ambient temperature: Lower than 40
g)Operating pressure up to achieves 2.5MPa

5. MATERIAL 

a)Pump casing: Cast iron or magnesium iron
b)Pump cover: Cast iron or magnesium iron
c)Impeller: Cast iron, magnesium iron or tin bronze
d)Sealing ring: Cast iron or tin bronze
e)Pump shaft: 45# steel plated with chrome
f)Dynamic and static mechanical sea: Hard carbide, graphite
g)Configuring other material according to requirement is allowable

Rated flow

10(m3/h)

Rated head

26m

Rated power

1.5Kw

Voltage

220V

Rated Current

7.2A

Rated speed

2860r/min

Discharge diameter

50mm

6.Conditions of use

Pumps used in the following conditions should be continuously to work properly: 
1. For water pumps suitable medium, medium temperature shall not exceed + 40°C
2. The medium PH value between 6.5 ~ 8.5 
3. The volume of medium containing solid impurity is less than 0.1%, the size is not more than 0.2 mm 
4. The power frequency 50 hz, voltage for single-phase 220 v, 380 v, three-phase voltage fluctuation range for rating of 0.9 to 1.1 times 
5. Diving depth of no more than 5 m, is not suitable for irrigation and drainage of sewage and chemicals.

Water Pumps Cheap Centrifugal Good Quality Made In China

Water Pumps Cheap Centrifugal Good Quality Made In China


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:looking for kickstart, a small water pump developed for east africa?
previously ApproTEC. KVM-Thika, a local manufacturing firm in Kenya. Micro-Irrigation Technologies. Rural Kenyans can no longer rely purely on subsistence farming. ... However, this pump can only pull water from a well ... wanted to pump water up to their fields on the sides of hills. So in October 1998 KickStart introduced the ...
Q:97 dodge van 3.9 water pump?
I,m with JOHN R in this one, confirm your radiator fan seize is working and not purely unfastened wheeling all of the time and additionally confirm that there is no air trapped interior the cooling gadget.With engine off crack a heater hose unfastened close to the heater center and pour anti freeze in until it starts to return out the disconnected hose. And the cooling fan could become noticeably louder whilst the engine is heat and in case you shut the engine off it is going to experience stiffer to coach than it does cool. sturdy success.
Q:What will the water pump reversal situation?
The same will reverse pump water, but the head and the pressure greatly reduced, I just finished debugging a pumping station, Stephen multi-stage pump, installation of equipment: multistage water pump motor power 4 75KW 76% head 100 meters, frequency control, motor nameplate nominal current of 143. According to the direction of the motor steering pump mark OK set the start time of 28 seconds after 5HZ boot head start frequency can reach 50 meters (at that time did not install the pressure gauge cannot observe the water pressure of current) in early 118 about 3-5 minutes after the current is reduced to about 97, there are inspection found no problems, suspected pump problems, suspected foot valve not completely open, the reason cannot exclude the end of valve, almost in despair when the thought is not marked in the direction of the pump, re set to restart the current 129.5A to observe that later installed capacity reached 0.55MPa duct pressure gauge head close to the design requirements, the problem on the manufacturer's mark is reverse.
Q:How to check a water pump on a 1998 Dodge Dakota V6?
check for leaks in the system, the water pump may show signs of leaks or perhap even make a noise, flush out the radiator, it may be stopped up preventing good circulation, make sure thermostat is installed properly, if there is no signs of leaking,or no noise such a a bad bearing, or water pump not loose when you try to shake it, most likely I would change out the heater core.. and also replace the radiator cap so the system is properly pressurized.
Q:Why is water pumping cool water is normal, but when pumping hot water pressure and flow are very small?
There may be: first, the water temperature is too high, the impeller damage! But this may not be very likely! Second, but also the water temperature is too high, but may be too high water temperature will be hot water pipe deflated, resulting in no water. Third, it is possible to buy fake and shoddy products!!! Another important problem is that you didn't tell me what kind of pump it was! What forms of work do you have?
Q:Should I replace my water pump?
additional cost on parts, water pump. for labor, no extra charge for it, since the area is already open, you may ask mechanic to install water pump together with timing belt, bargain with the mechanic...
Q:Why can't sprinkler system and hydrant system share water pump in fire fighting system?
The design code of sprinkler system GB 50084 - 2001 (2005 Edition) stipulates that the sprinkler system shall be provided with an independent water supply pump, that is, the water pump shall not be shared with the hydrant system. The aim is to ensure the reliability of the water supply and prevent interference.See the code for design of automatic sprinkler system, GB 50084 - 2001 (2005 Edition), 10.2.1 and the corresponding provisions of the following interpretation.
Q:1998 Honda Civic Water Pump and Coolant?
Like the answerers above me the Water Pump and Coolant wouldn't have anything to do with your car idling roughly. The cooling system's job is to maintain all internal engine components at a level, stable tempature.The water pump is resposible for keeping the flow of coolant throught the engine block If your car was was running low on coolant, or the water pump stopped working, the engine temperature would increase, increasing the risk of engine oil breakdown and blowing a head gasket. Rough Engine idling could be diagnosed simply as a throttle bottle cable that needs to be adjusted (adjust to increase or decrease engline idle) or a vacuum hose that is loose/leaking (rubber lines that run from the engine's intake). These would be the first things I would inspect and it is very simple.
Q:Chevy hhr water pump replaced and came back with more problems.?
Matbe they forgot to replace water pump gasket, timing belt not aligned with timing of engine.
Q:Location of 2000 Impala water pump?
water pump is located on pass side of the motor right where serpentine belt is

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range