Real Wood Hardwood Flooring

Hot Products

FAQ

Home to use to warm, but want to use Finney's cooling water heater, do not know how to combine?
To warm the general use of fireplaces, water heaters for life hot water, does not affect. If you want the two sets, it involves the system integration, and need to see your system and want to achieve the function to match the controller and control valve, and for the HVAC professional is not a complex State sleep pumpkin mixed, but do not understand or very hard.
How to connect the natural gas boiler
How is the natural gas boiler connected to the warm pipe? Of course, through the water separator and the water collector to connect.
What is the principle of warm What do the fuel
What is the principle of warm What do the fuel...
Water tank plus electric heating tube to give warm when the heat source
If you only use this water when heating, it is possible. But pay attention to the cycle
Home coal-fired heating stove and electric heating furnace which is good
Coal, cheap to save money. Electricity, clean and easy to control, expensive
What is the difference between the hydraulic module and the original hydraulic module? Please master as much as possible to say the details?
Energy-saving air-conditioned room is in the original ordinary air-conditioning room structure, the traditional room of the pump, the valve group, filter decontamination equipment, energy-saving equipment, supporting parts and control systems of these components together. Used in warm air conditioning water system in the water medium power transmission and control and connect the host and the heat transfer end of the pipeline, in series to form a standardized equipment. Equipment through the professional staff according to the real shortage of speculation in the past, the need to match the various components to the most economical and energy-saving program customization
To install the mixed water center also installed with a pressure differential bypass valve
The role of mixed water center is mainly to adjust the warm water supply problems, to achieve automatic control of water supply temperature. Reason: According to the provisions of the country to warm the installation, the water temperature should not be higher than 60 ℃: 1, to prevent the warm water in the warm pipe, water mixers and other heating system components in the scale. 2, to warm the pipe material for the plastic material, the higher the temperature of the working environment, the greater the pressure, will shorten the warm life. Municipal central heating more in accordance with the heating film heating temperature of 80 ℃ to the water, far more than the warm to apply the highest temperature. The mixed water center can mix the low temperature water of the heating system backwater into the water supply pipe, lower the heating water temperature, and then supply it to the floor. Refer to the following figure: Madison fireplace, dedicated to your service.
What is the warm working principle of what is warm
To warm the floor is the radiator, through the floor of the radiation layer of the heat medium, the uniform heating of the entire ground, the use of the ground itself, the heat and heat up the law of radiation from the bottom to the conduction, to achieve the purpose of heating. From the heat medium is divided into water to warm and warm air to warm the dry Gan Nao imitation wet wet splash two categories, water heating is the water heated to a certain temperature, transported to the floor under the water pipe cooling network, through the floor fever To achieve the purpose of heating a heating method. Electric heating is the use of electricity to convert heat, it is recommended to use water to warm, more environmentally friendly and healthy energy! best regard!