Chemical Multi-stage Pump

Ref Price:
Loading Port:
Payment Terms:
TT or LC
Min Order Qty:
1 unit
Supply Capability:
1000 Sets Per Month unit/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

It can be applied to refineries,petrochemical industry, coal chemical industry, cryogenic engineering, water supply factory, sea water desalination factory, heat supply and air-conditioning system,etc.

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:How to judge the good and bad of automobile oil pump?
Look, noise is too large, pump basically scrapped, two look at oil pressure, oil pressure is too difficult to start
Q:How to change the diesel engine oil pump?
The oil pump of the diesel engine has a built-in (in the oil pan), and there is an external (installed outside to see). Built in need of oil removal shell, the external direct disassembly can be replaced. When changing, pay attention to the bearing clearance and the transmission gear. When there is no timing, it is very simple. The gear pump mainly checks the axial clearance
Q:The oil pump is not working well. What about the engine?
Can not afford oil
Q:Manual transmission, organic oil pump, automatic, stepless?
There is no oil pump in the manual transmission, there is automatic, that is, the non-polar.
Q:JMC 462Q engine does not go to the cylinder head, where is the oil pump located?
You can't fix it by yourself.1, remove the valve compartment cover, you can see the rocker shaft, loosen the top of the middle fixed screws.2 you can blow it up in a high pressure air pump, clear it up, start the engine, and spray the oil outward.3, also can use steel wire (about 50cm long, rough 1mm or so, can reach that hole), to dredge, must exceed 25mm (cylinder head height) just go.4 or more can not work, and finally only remove the cylinder head.The 5 reason is that the cylinder pad (oil hole) is blocked by carbon deposits, and the engine oil can not reach the rocker arm.
Q:How does the c4l determine whether the oil pump works? The oil lamp is on
The oil pump is basically mechanical, so you can try changing the oil sensor.
Q:Polo 1.4 changed the oil pump without oil
Replace the oil pump and clean the oil passages
Q:What's the cause of the indicator light of the car oil pump?
It's the oil pressure indicator, not the oil pump indicator light.This indicator is used to show the pressure of the engine oil. Open the key door. When the vehicle starts to self check, the indicator light is on and off after starting. The indicator light is always on, indicating that the engine oil pressure is lower than the required standard, you need to repair.If it's on all the time, just see if the oil is enough. How about the oil pressure switch, the wiring harness and the plug?. If it is flashing at some point, the possibility of a problem with the oil pressure switch itself is greater.
Q:Why does the engine oil pump need good timing?
In the gasoline injection system, the fuel pump is an extremely critical component, once the fuel pump fails, the car will have a variety of adverse symptoms.First, the fuel pump failure, what problems will bring to the car?1, the engine can ignite, but can not start2 the fuel pump may leak inside3, excessive noise4, lack of motivation5. When you hesitate, speed upTwo, maintenance suggestions1. Most modern electric fuel pumps for automobiles are installed in the tank. Some vehicle access panels can be removed by replacing the pump without removing the fuel tank.2, tank fuel pumps are submerged in fuel to help them stay cool. The gas will destroy the fuel pump.3, fuel filter replacement fuel pump should be replaced4 fuel filter obstruction or electrical system driving fuel pump problems may cause symptoms similar to a failed fuel pump. The store confirms that the pump is in place before replacing it.5, gasoline is highly flammable. When replacing the fuel pump, the battery should be disconnected and proper safety procedures are provided to avoid fire and personal injury.
Q:Motor home, in which case, the oil pump will not be able to pump oil
The oil pump will not work if it breaks down.
Our main products are all kinds of centrifugal pumps, displacement pumps and vacuum pumps, such as oil pumps, multi-phase pumps, single stage and double suction centrifugal pumps, horizontal split case pumps, multistage pumps, axial-flow pumps, mixed flow pumps, petrochemical pump and submersible pumps. Besides, our company also manufactures electric motors and sells electric motors, building materials, indoor decoration materials, civil electric equipment, devices and instrumentation, as well as exports our mechanical and electric products.

1. Manufacturer Overview

Location Hunan,China
Year Established 2006
Annual Output Value US$5 Million - US$10 Million
Main Markets 59.00% Mid East
8.00% North America
8.00% Southern Europe
5.00% Eastern Asia
2.00% Africa
2.00% Oceania
2.00% Southeast Asia
2.00% Western Europe
2.00% South America
2.00% Central America
2.00% Northern Europe
2.00% Eastern Europe
2.00% South Asia
2.00% Domestic Market
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Export Percentage 51% - 60%
No.of Employees in Trade Department 6-10 People
Language Spoken: English, Chinese
b)Factory Information  
Factory Size: Above 100,000 square meters
No. of Production Lines Above 10
Contract Manufacturing OEM Service Offered Design Service Offered Buyer Label Offered
Product Price Range High and/or Average