According to differences in working medium and temperature as well as material and structural chagenges of the flow-through part, it can be desined and manufactured into pipeline oil pump.
- Q:From where on the car can you see that the oil pump is not oiled?
- The oil alarm light is bright and the valve is noisy
- Q:JMC 462Q engine does not go to the cylinder head, where is the oil pump located?
- Open the cover, find the path to head road oil cylinder, a simple way is to start the machine, idling, if the normal, a little while the oil will flow out from the oil, and then find what fault cylinder pad or cylinder head.
- Q:Questions about the old Chery, the oil pump and the engine
- Bearing for a set or a low pressure, caused by many reasons, when you hold tile caused by the lack of oil, bearing should replace all, then replace the oil pump, oil lubrication is not good water temperature will be high, the fuel with the lights to replace the sensor
- Q:How much does the engine oil pump service cost?
- General 170-180
- Q:How to dismantle the oil pump chain saw
- Komatsu? 4500.5200.5800, because the clutch is anti wire, you can only use the son rushed out of iron bell. As soon as you clutch, you'll see.
- Q:I wonder if the pressure of the pump is not enough. What will happen to the car?
- Gasoline pump pressure is bad, first speed can not afford. Another condition is that the half tank will stall.
- Q:110 engine oil pump gear is always broken, what should I do?
- Like to change a good, do not like
- Q:What's the use of the oil pump for motorcycles?
- Two stroke engine oil pump is regulated through cable, throttle in the middle line will be divided into two, one to one to the carburetor, the oil pump, the throttle fully closed, then adjust the speed nut oil pump on the cable, the cable to completely relax, this is the minimum amount of oil, but be careful not to too loose, when the twist of the throttle, engine oil pump should follow the action, there is a situation of oil pump through internal wear caused by excessive amount of oil used for many years, this situation can not be adjusted, only the replacement of oil pump.
- Q:In the 1 to 2 seconds when the vehicle is started, does the oil pump inject engine oil into the engine?
- Yes, the oil pump follows the crankshaft
- Q:What is the influence of insufficient oil supply in the oil pump?
- Will cause abnormal engine performance and output power decline. Difficult to start; the car is weak; the car will shake when it opens
Our main products are all kinds of centrifugal pumps, displacement pumps and vacuum pumps, such as oil pumps, multi-phase pumps, single stage and double suction centrifugal pumps, horizontal split case pumps, multistage pumps, axial-flow pumps, mixed flow pumps, petrochemical pump and submersible pumps. Besides, our company also manufactures electric motors and sells electric motors, building materials, indoor decoration materials, civil electric equipment, devices and instrumentation, as well as exports our mechanical and electric products.
1. Manufacturer Overview
|Annual Output Value
||US$5 Million - US$10 Million
||59.00% Mid East
8.00% North America
8.00% Southern Europe
5.00% Eastern Asia
2.00% Southeast Asia
2.00% Western Europe
2.00% South America
2.00% Central America
2.00% Northern Europe
2.00% Eastern Europe
2.00% South Asia
2.00% Domestic Market
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||51% - 60%
|No.of Employees in Trade Department
||Above 100,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range
||High and/or Average