Q:how do you install bathroom sink faucets?

1. make sure you have at least 2 wrenches or 2 pair of pliers or something to loosen and tighten the lines. 2. Turn off the water valves under the sink. If you do not have valves under the sink you will have to turn the entire house off. If the latter is the case, make sure you buy some valves to put under the sink before you turn the water back on. It would suck to be without water if something goes wrong and you do not have valves to make sure your bathroom doesn't flood. 3. Turn the faucet on and make sure all the water is drained--if it continues to drip then try playing with the valves some more--but realize that they are not indestructable and could break if you put too much umf into em. 4. Unhook the water lines from the old faucet using two wrenches usually. If your old water lines are not in good shape, it is the perfect time to get new and have one less thing that can go wrong. 5. If you are not sure, write on the wall or the back side of the cabinet which is hot or cold so you don't hook em- up wrong on the new one. 6. Loosen the nuts (usually plastic unless really old) on the bottom side of the faucet itself. The faucet will pull out through the top once these have been removed. 7. Clean up any remaining residue from the old faucet. 8. Follow directions that come with the new faucet. Should take between 15 minutes and 1? hours--depending on how hard it is to get to and how long and old the existing faucet is. If you get in a bind--then you can call someone to come do it for you--but there is no science to replacing a faucet. Have fun-I hate plumbing--unless everything works right.

Q:What is the drainage of the basin with good drainage?

Wall drainage is not much shortcomings, but the construction should pay attention to the first waterproof on the wall; into the wall drain connection should be close. It is not likely to cause clogging.

Q:how do you clean an acrylic bathroom sink basin?

Any bathroom spray and a cloth should do it But if its really bad use magic eraser

Q:Tried cleaning all pieces. Made rope of plumbers putty, slipped it under flange and then tightened down. Looks like most of putty oozed out. water does not drip from under sink, it just runs into drain.

I have used teflon tape with success in sealing threads on home projects. I have also used clear, silicone adhesive, Goop with good results. Plumber's putty was originally designed for cast iron fittings and not brass or pvc pipe fittings. Teflon tape comes in different colors where each applies to a specific type hook-up; liquid and gas. So, check the label before purchasing.

Q:Bathroom washbasin porcelain surface dirt how to clear out?

Alkaline cleaners can remove all kinds of animal and vegetable greasy stains and mechanical oil, and can remove the ground wax layer. Such as special enhanced oil cleaning agent; strong wax from the water. Acid and alkaline cleaning agents, if used improperly, in addition to causing a waste of cleaning agents, but also to varying degrees damage to the surface of the cleaning material, and may even cause the user's skin or eye damage.

Q:How to remove the column basin

Washbasin is generally fixed with the expansion bolts on the wall, you can use the wrench unscrew the back of the wash basin to remove the screws; the following pillars are only placed on the ground and a little fixed with white cement, remove the wash basin can be taken directly The hot and cold water pipe connected to the washbasin can be unscrewed with pliers.

Q:how to unglue a bathroom sink from the wall?

you cant unglue something like that, it can be possible to pry it off the wall if it is sheetrock, the paper on the sheetrock might give before the sink breaks. if it is siliconed around the edges, as some contractors use this as a way to fasten sinks to the wall, then cut it with a utility knife and pry around it as you go. if it is constuction glue on plaster, your screwed unless you have a diamond grinder to cut the wall around the sink and pry it off that way. also, if it is silicone, make sure to cut around the outside edge so you dont tear the paper up the wall

Q:The sink in my bathroom is backing up. Does anybody have any trick to unclog it. I'm not sure about using drain'o. I heard that just makes it worse.

Use a plunger and after the clog clears, fill the sink full of hot water and drain it. plung some more if you have to.

Q:Jingdezhen art basin where to sell, what are the style. how's the price?

Hua Hin Art Basin

Q:What is the quality of the wash basin, what are the different types of washbasin material?

Ceramic pots relative to the steel plate style is not very diverse, and because of the fragile material, it can not bear the impact or heavy impact. Nevertheless, many brands still prefer to use ceramic pots, because the simple ceramic basin is easy to match the different styles of bathroom furniture, mostly white, and it is easy to clean, not easy to contaminate.