High Quality Mono Crystalline Solar Panels for Kids

High Quality Mono Crystalline Solar Panels for Kids System 1

High Quality Mono Crystalline Solar Panels for Kids System 2

High Quality Mono Crystalline Solar Panels for Kids

Ref Price:

Loading Port:: China main port

Payment Terms:: TT or LC

Min Order Qty:: 1 pc

Supply Capability:: 1000000 pc/month

Inquire Now

Add to My Favorites

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Product Description:

Monocrystalline Silicon Solar Panel

Introduction of Monocrystalline Silicon Solar Panel CNBM Solar photovoltaic (PV) Panel is designed for large electrical power requirements. It is the optimal choice for both on-grid and off-grid power systems. CNBM Solar panel offers high performance of power per square foot of solar array. Monocrystalline silicon(c-Si): often made using the Czochralski process. Single-crystal wafer cells tend to be expensive, and because they are cut from cylindrical ingots, do not completely cover a square solar cell module without a substantial waste of refined silicon. Hence most c-Si panels have uncovered gaps at the four corners of the cells.

Characteristics of Monocrystalline Silicon Solar Panel

I Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.

II Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.

III EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V Junction box: Multi function junction box with water proof.

VI Long lifetime: ≥25 years; Less power decrease.

VII Good performance of preventing from atrocious weather such as wind and hails.

VIII Resisting moisture and etching effectively, not effected by geology. Standard Test Conditions of Monocrystalline Silicon Solar Panel The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.

Advantages of Monocrystalline Silicon Solar Panel

Characteristics of CNBM Solar Monocrystalline Series (45W-65W)

Max Power Voltage Vmp (V)	17.8V	18.0V	17.6V	17.8V	18.0V
Max Power Current Imp (A)	2.53A	2.78A	3.13A	3.37A	3.61A
Open Circuit Voltage Voc (V)	22.4V	22.6V	22.2V	22.4V	22.6V
Short Circuit Current Isc (A)	2.74A	2.97A	3.35A	3.61A	4.36A
Max Power Pm (W)	45W	50W	55W	60W	65W

Temperature Coefficient of Cells of CNBM Solar Monocrystalline Series (45W-65W)

NOCT	47℃±2℃
Temperature Coefficients of Isc (%/℃)	0.064
Temperature Coefficients of Voc (%/℃)	-0.33
Temperature Coefficients of Pmp (%/℃)	-0.45

Mechanical Data of CNBM Solar Monocrystalline Series (45W-65W)

Power	45W/50W	55W/60W/65W
Dimension	630×550×30mm	820×550×30mm
Weight	4.5kg	5.5kg
Tolerance	±3%	±3%

The dimension of the modules can be changed according to the demand of clients

Limits of CNBM Solar Monocrystalline Series (45W-65W)

Operating Temperature	–40 °C to +85°C
Storage Temperature	–40 °C to +85°C
Max System Voltage	700V

Guarantee of CNBM Solar Monocrystalline Series (45W-65W)

Products Guarantee	2 yrs free from defects in materials and workmanship
Performance Guarantee	No less than 90% within 10yrs and no less than 80% within 20yrs
Certificates	IEC, ISO, TUV, CE

IMAGES:

Mono Crystalline Solar Panels with High Quality

FAQ:

WHAT'S THE ADVANTAGES OF CNBM?

1.CNBM is a state-owned company under jurisdiction of central goverment , one of Fortune 500 .Just because of this ,we can get more support and resources from our government.So ,it is realiable .

2.CNBM's solar products are high-qualified with TUV,UL,VDE,CE,ISO certificates. Our products ranges top in China.

3.Just as I mentioned in attahment ,we signed 500MW project with Urkan under the witness of our chairman Xi Jinping ,CNBM has ability to meet your large quantity needs,Our annual capacity is 1GW.

4.We can offer you a competitive price .Because you are our potential and valued customer .

Q:I am looking to get some solar panels for my home to just power a few lights, a fan or two. I have a generator but I want that only to power the fridge and maybe some other small stuff for convenience.But mainly want the solar panels for the lights and fans. Any one have an idea of how about I go to figuring this all out? Should I call a contractor or anything?: depends on what light bulbs you have in watts.depends on how many you want on. for the power equation you take P which equals watts x I which equals amps and E which equals volts and you multiply the amps and the volts together to get the watts which the solar panel is generating. for example if you had 7 60 watt light bulbs you would need 420 watts generated. which if you got 50 watt panels each you would need 9 panels. and for what your talking about if you want the stuff to work when the power goes out you are going to need an inverter. not to be confused with a grid ti inverter. and a few batteries i recommend deep cycle batteries that are meant for solar panels. depends on what fan you have.

Q:I live in a higher LATITUDE so in the winter months, there is a limitation in the amount of sunlight available, but will this impediment restrict the ability of solar panels to function due to the lack of sunlight involved?: Solar panels generate power only during sunshine hours. But they only need sunshine, they don't like the heat, that comes along with the sunshine. So its a trade off, the places that have a lot of sun, also have a lot of heat, and places that do not have a lot of sun are not that hot. But you do need sunlight to run solar panels. There's a lot of tools available which can tell you how much power you are able to generate given your location.

Q:are solar panels just a photodiode?A Photodiode converts light into either current or voltage? Right?: yes. Any semiconductor junction will convert light into electrical energy, just shine a light at an LED (connect LED to voltmeter) and you'll see a small voltage produced (if you configure the meter as an ammeter it will develop a very small current). Solar panels are just VERY large surface photodiodes.

Q:Which kit did you use?How easy was it to build? How much did it cost to build the panels?How many kw or watts does it produce?Any other info on the kit or panels you built would be helpful.Thanks!: the kit is a fraud and should be ignored. You cannot make a solar panel at home to the quality and output that professional ones are. It's like thinking you can buy chips and make your own PC.

Q:I have a home made 24 volt electric cart. It is powered by two 2Volt deep cycle batteries. Since the motor runs on 24 volts the batteries are wired in series to produce the 24 volts. I only have a 2 volt battery charger, but I also have two 2 volt solar panels. It is a pain having to unhook wires, rewire it, or charge them one at the time.HERE IS THE QUESTION REALLY... Can I wire the two 2 volt solar panels together in series (ie: negative to positive) then connect it to the existing 24 volt system and have it charge the batteries fine. I know basic wiring, but I know nearly nothing about solar panels, will it work fine? will it cause them to break? or short out?(additional info, the solar panels are only rated at 5 amps so it will not overcharge the batteries or anything): Although I'm not experienced with solar panels, I would say no. if you wire them in series you'll actually be putting voltage through one of the panels. Can't believe this would be good. My suggestion would be to wire one panel to one battery and one panel to the other battery. I really don't believe there's a need to disconnect the batteries from each other. However if you would disconnect the one wire between the two batteries you would be guaranteed safe and I know that would work.

Q:am having a 75 watts siemens solar panel and is giving me 2.89volts during bright light, i wanted to know can this be used to charge 00Am/hr battery?: Many of the panels used on homes are designed to produce 2 volts DC. 0 of them wired in a series would produce 20 volts DC. An inverter is used to change the DC voltage to AC. The other aspect of electricity is amperage. With electrical units wired in series the voltage is added. When they are wired in parallel the amperage is added. The Volts x Amps produced will give you the wattage. A wise homeowner will examine their electric bills or the equipment used to determine their demand. They will consult tables that let them know how much sunlight their area receives each year as this will alter the rated performance of the panels. Then they will try and determine how much of the demand they want to fill. 80% may be economical. Then they also want to determine what they will do with excess electricity that may be produced during the summer months of intense sun and how they will supply the shortfall of low sun winter months. From all this they will determine the number of solar panels they need to purchase.

Q:Can solar panels be installed on a pergola or gazebo structure?: Yes, solar panels can be installed on a pergola or gazebo structure. These structures provide a suitable surface for mounting solar panels and can help maximize the exposure to sunlight, ultimately increasing the energy production of the panels. It is important to ensure that the pergola or gazebo is structurally sound and properly designed to support the weight and wind load of the solar panels. Additionally, the orientation and angle of the panels should be optimized for the specific location to maximize energy generation.

Q:Can solar panels be used during a power outage?: No, solar panels cannot be used during a power outage unless they are connected to a battery storage system.

Q:A few months ago my dad said something about getting solar panels, and how green they were. I was just wondering if there were any companies that sold them and if they would actually make a big difference.: Yes there are companies that sell solar panels, many of them specialize in solar, a simple google search with your state or city name and the word solar should get you many results. There are actually two kinds of solar panels that get installed on homes, one kind creates electricity, the other heats up water. Depending on how large a system you installed, you could have all of your electricity or hot water powered by solar, which would mean you'd use less nonrenewable resources like coal, oil, or natural gas. The other difference the solar panels would make would be in your electric or gas bill, that number would go down right away, but you'd have to wait a few years before the money you save there would cover the cost of buying the panels, the number of years depends on your state, and the size of your system. Starting in January there will be a 30% federal tax credit, that would mean savings for every installation in the US. Also a lot of states now have a rebate program, which means the system is even less expensive.

Q:I'm thinking of doing solar panel but i don't know how much they are i need help! please!: no one has answered because you asked a question that cannot be answered. It is exactly the same question as how much is a car?. Do you want a passive solar heating panel, a solar electric panel, .5 Volts, ,000,000 BTUs, do you want just the panel or the panel installed and functioning, or what? the answer is between $5 and $5,000,000.

1. Manufacturer Overview
Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates
a) Certification Name
Range
Reference
Validity Period

3. Manufacturer Capability
a)Trade Capacity
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range