Solar Poly Panels (100W-120W)

Ref Price:

Loading Port:: Shanghai

Payment Terms:: TT

Min Order Qty:: 1 piece pc

Supply Capability:: 100000 pieces /month pc/month

Inquire Now

Chat Online Add to My Favorites

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Details
FAQ

Inquire Now

Product Description:

Solar Poly Panels (100W-120W)

Introduction of Solar Poly Panel (100W-120W)

High and stable conversion efficiency based on over 8 years professional experience
High reliability with guaranteed ±3% output
Power tolerance proven materials, tempered front glass, and a sturdy anodized aluminum frame
allow modules to operate reliably in multiple mountily configuration.
Combination of high efficiency and attractive appearance

Characteristics of Solar Poly Panel (100W-120W)

I Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.

II Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.

III EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V Junction box: Multi function junction box with water proof.

VI Long lifetime: ≥25 years; Less power decrease.

VII Good performance of preventing from atrocious weather such as wind and hails.

VIII Resisting moisture and etching effectively, not effected by geology. .

Standard Test Conditions of Solar Poly Panel (100W-120W)

The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions of multicrystalline silicon Solar Panel, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.

Advantages of Solar Poly Panel (100W-120W)

• CNBM Solar performance guarantees for 25 years

• 2 years guarantee for workmanship for multicrystalline silicon Solar Panel

• Timeliness of delivery

Characteristics of Solar Poly Panel (100W-120W)

Max Power Voltage Vmp (V)	17.8V	18.4V	17.8V
Max Power Current Imp (A)	6.18A	6.52A	6.74A
Open Circuit Voltage Voc (V)	22.4V	23.0V	22.4V
Short Circuit Current Isc (A)	6.61A	6.97A	7.21A
Max Power Pm (W)	100W	110W	120W

Temperature Coefficient of Cells

NOCT	47℃±2℃
Temperature Coefficients of Isc (%/℃)	0.064
Temperature Coefficients of Voc (%/℃)	-0.33
Temperature Coefficients of Pmp (%/℃)	-0.45

Mechanical Data of Solar Poly Panel (100W-120W)

Power	100W	110W	120W
Dimension	1120×670×30 mm	1190×670×30 mm	1330×670×30 mm
Weight	9.1kg	9.5kg	10.6kg
Tolerance	±3%	±3%	±3%

The dimension of the modules can be changed according to the demand of clients

Limits

Operating Temperature	–40 °C to +85°C
Storage Temperature	–40 °C to +85°C
Max System Voltage	700V

Guarantee of Solar Poly Panel (100W-120W)

Products Guarantee	2 yrs free from defects in materials and workmanship
Performance Guarantee	No less than 90% within 10yrs and no less than 80% within 20yrs
Certificates	IEC, ISO, TUV, CE

The Equipment of Solar Poly Panel (100W-120W)

Solar Polycrystalline Panels (100W-120W)

The Production Line of Solar Poly Panel (100W-120W)

Solar Polycrystalline Panels (100W-120W)

Send a message to us:

Email:

Telephone:

Qty Required:

Company:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:I want to Build a solar Panel.?: that will sell a ready-made panel for less than that. Note that when someone puts up free instructions, they usually have lots of pictures of themselves and what they made, step-by-step. What I have noticed in all of the review sites for solar guides is that they never have a picture of what they made, in spite of their claims to have tried the guide. At best, all I see is stock pictures from the guide.

Q:what is the best solar panels to use on my new house(tube or flat)?: I assume you're talking about heating water. Based on what I've seen, the spiral tubes seem to heat the water to a higher temperature than the flat panels, probably because the water has to follow a longer path and has more time to heat. This type of panel will heat the water to a high enough temperature for almost any household application, but you need to be careful about how you set it up. I once saw a pool that had been equipped with that type of heating system, and it produced enough heat to melt one of the PVC pipes. It was a vertical pipe next to the filter, and it had fallen over onto the ground, pinching off the flow of water. This was in Arizona, so it may not get that hot in your area.

Q:You place four identical solar panels in 4 places.?: Best to worst: far side of the moon, near side of the moon (same as far side, except for lunar eclipses), Sahara desert (not at 0 latitude, and occasional bad weather), New England (less favorable latitude, and LOTS of bad weather).

Q:Solar panel connected to battery ??: You really need a little more infomation about your battery. It should have a recommended range of charging current. You should not exceed that range. Your solar cells must be a higher voltage than the battery, but you should not connect the cells directly to the battery. First, you need a diode in the line to keep the battery from draining into the solar cells when there is no light. Second, you need a resistor to limit the charging current. You have a 3.6v battery. Let's say the charging current is 0.A. Use a 5v solar cell and silicon diode. The diode will drop the cell voltage to 4.3v. The voltage across the resistor will be .7v for .A current, you need a 7-ohm resistor.

Q:Amount of solar panels needed to run a/c and pool pump?: Solar panels are not going to be able to run a pool pump 24/7. They will only produce their rated electricity for 4 to 8 hours a day. For the balance you will need a grid connection or a battery backup. Running the AC would require different power levels depending upon humidity, outside temperature levels, solar gain for the house, and insulation levels. An underground house in Maine will be much easier to AC than a Glass house in Arizona. First find the power requirements. If you had the existing equipment they will have a label with the power requirements or the minimum breaker required if nothing else. For example the pool pump may require a 0 amp 240 breaker while the AC may require a 30 amp 240 breaker. That would be 2400 watts for the pump and (30 x 240) 7200 watts for the AC or a total of 9.6kW each hour of operation. (max) You will next need to find the rated capacity of the solar panels. If each panel were rated at 300 watts then you would need 32 panels for the daytime use and perhaps more to fill in a battery backup. All the numbers are very rough estimates.

Q:Why don't scientists use the design of a tree for solar panels?: From the vantage point of a scientist and an engineer, you have a whole host of problems to overcome. The mass of solar cells cannot be supported by most leaves much less allow the leaves to turn toward the sun as they naturally do. The wood and other structures of a tree are terrible conductors and wouldn't serve as efficient power transmitters. There are issues of damaging the health of the tree by interrupting the process of photosynthesis in favor of solar energy collection, and many other issues. However, I can tell you that solar power does use several principals that you have observed in trees. For example, solar collectors are almost always oriented to face toward the sun. Many adjust with the time of day and seasons to be optimally oriented to collect the sun's rays. Much like leaves in many plants are not static but change position to optimize their angle to the sun. Also, many solar cells are now designed with a membrane structure which offer several advantages. So you see many of your observations have found their way into practical application in solar power production.

Q:Solar panel for your home?: it all depends on how much electricity you use for heating/cooling and cooking.......if you just need lights, TVs etc then you could get away with about $5-8,000 US for a system depending on how far north you live.....to go completely off the grid is near $25,000 by the time batteries and inverters and all of that is figured in....

Q:lighting my pond with solar panels?: select 2V, and it will tell you how big of a battery bank and how big of a solar panel you need. For my example, I need a 7ah 2V battery and a 20watt panel.

Q:Questions about Solar Panels and Battery back ups.?

Q:What direction do solar panels usually point?: Oh wow, please ignore approx 50% of the answers here. We live off-grid and solar is my business. If you are in North America, they should face SOUTH. The comment about them facing the equator is accurate. What has not been said though, is the angle they should be at. For optimal sun exposure, the angle from horizontal for the panel should be equal to your latitude. So if you live in Colorado for example, at approximately 40 degrees latitude, your panel should be at 40 degrees from horizontal.

1. Manufacturer Overview
Location	Jiangsu, China
Year Established	2004
Annual Output Value	Below US$1 Million
Main Markets	Australia；Asia；South East Asia; South America；North America； Europe；Africa
Company Certifications	ISO 9001:2008; CE; TUV; UL

2. Manufacturer Certificates
a) Certification Name
Range
Reference
Validity Period

3. Manufacturer Capability
a)Trade Capacity
Nearest Port	Shanghai
Export Percentage	1% - 10%
No.of Employees in Trade Department	200-300 People
Language Spoken:	English；Chinese
b)Factory Information
Factory Size:	Above 8,000 Square meter
No. of Production Lines	6
Contract Manufacturing	OEM Service Offered；Design Service Offered
Product Price Range	Average