Stainless Steel Beverage Tub

Hot Products

Modern Rose Gold Plated Bath Faucet

Kichen Faucet, Two Handle Brass Tap

Antique Brass Body Basin Faucet With Two Zinc Alloy Handles

New Design Antique Plated Faucet With Two Handles

Contemporary Bathroom Faucet Kitchen Faucet MSCN-16575

Two Blass Handle Chrome Plated Brass Body Faucet

Swan Shape Double Handle Faucet

Three Blass Handle Chrome Plated Bathroom Sink Square Faucet With Shower

Gold Plated Bathroom Sink Faucet Mixer Two Handles

2014 Newly Design Handle Brass Faucet Tap

FAQ

My water faucet has a male thread at its outlet. I am trying to determine the thread size and type so I can order some fittings. I measured the outer diameter with a caliper and it was about 0.79 (20mm). I tried a 1/2 NPT female fitting and it barely didn't fit.I need to know if it is metric, BSP (British standard pipe), NPT (National Pipe Thread), or garden hose.Thanks!

well it depends, what brand is it ? and what is it ? a sink faucet, wash basin faucet ? single knob ? double knob ? garden hose picket , does it have a aerator on it / INFO INFO,

i got the old faucet off just fine, but am having trouble reconnecting the water supply. every time i try to screw it on it starts out fine when i twist it on with my fingers, but as soon as i try to tighten it further with the basin wrench both hot and cold lines screw on very crooked. after a couple of tries i thought maybe it wouldnt cause that much of a problem so after i turned them as far as they would go i turned the valves back on to see and water sprayed everywhere. what am i doing wrong?

Oh I bet you got the wrong sized supply lines. Take one back off and compare it side by side with the old one. I bet ya, I bet ya!

Im trying to replace my faucet sink in my bathroom the bolts wont come off ! I tried using the wrench I have but it wont turn what can I do? is there another tool I can use

Yes, it is called a torch. A pencil torch, a regular berzamatic torch. Either will work. They cause the metal to contract and expand loosening the bolts.

The basin of the basin of hot water pipe is broken, how to replace

Water hose damage, just replace the hose, close the hot water angle valve, with a wrench counterclockwise to loosen the hose connection angle valve hot water pipe hex nut, counterclockwise hose rotation, release hose and faucet The connection thread of the nozzle. If the time is longer, the thread rust, it may be difficult to twist, you can put the hose 90 degrees and then pull. Holding the old pipe to the plumbing store, buy a hot water pipe to re-install it. Note that the end of the hose connection faucet has a long, short head difference. The other end is G1 / 2 of the joints, generic.

What is the use of the hole below the basin faucet, on the basin

You say is the double-hole faucet wash the face of it, a total of three, that is the middle of some double-hole faucet will highlight some of the middle, so stay

What is the size of the faucet mounting hole in the sink basin?

The mounting hole of the standard mounting table should be 35mm in diameter.

It is better to wash the faucet

Easy to use is easy to use, but easy to bad ...

What accessories are installed in the vertical basin?

Triangle valve, 50cm hose, raw material belt, basin basin faucet, silicone!