Q:My kitchen faucet got broken, so i am trying to replace it with a new faucet. But here is my problem. I CANNOT uninstall the old faucet!!!! The main screw that holds the old faucet got rusty and the space around the screw is so little, I cannot uninstall it. It is so tight and it doesn't come out....I feel like if I continue trying, it may totally ruin the screw and it may never come out...Is there any advice for that? Pls help me!!!!

SomeTimes a hack saw is a plumbers best friend, other times the bald alone is.

Q:Basin double hole faucet outlet pipe bottom leakage how to do?

Inside the pad is broken

Q:There is no way to directly from the basin leading to the water tank inside the bucket

With a large plastic bottle obliquely placed in the basin, near the tap at the dig a hole, the bottom of the hollowed out. Small empty at the faucet, so drainage.

Q:How do you competely shut a leaking faucet?

No my faucet is not leaking and nor has it been leaking. But now my toilet does run all the time. No it is not the same problem that CJ is having either. I wish mine was that simple, I would have already had it fixed by now if that was the case. Mine is in my travel trailer that I live in.

Q:how can i change the kitchen faucet and sprayer?

you can get a kitchen faucet with sprayer in various applications, rundown is : shut off water supply valves under sink, disconnect water supply lines from the shutoff valves to the faucet. there will be nuts holding the faucet and sprayer (if its off to the side) remove these with a basin wrench. (purchased at lowes, home depot) simply pull faucet upwards and out. reattach new faucet with plumbers putty on the base of the faucet and reset in sink. attach new nuts that hold faucet body down and tighten till putty compresses fully flat. remove excess, reattach new water supply lines to avoid leaky old used ones. reopen your shut off valves and check for leaks, tighten any loose fittings in case of a water leak - all in all, your new faucet will have a manual to assist as well -best luck

Q:I do not know much about handiwork but I am forced to do it anyway. I ordered a new hose (old one was leaky) for my kitchen faucet. I was able to attach the new hose to the faucet, but am having trouble connecting the other side to the water line.The line runs vertically and is in a tight corner which is preventing me from getting in there with plyers or a wrench. I try to turn the hose counter-clockwise against the water line it is attached to, but the awkward placement of the line is making it very difficult to exert direct forceI feel there is a special tool/ technique I can use to detach the old hose and attach the new onePLESAE HELP

Go to Amazon and enter this: Ridgid 31180 1-1/4-Inch-to-2-1/2-Inch Capacity 10-Inch-to-17-Inch Heavy Duty Telescoping Basin Wrench It will allow you to reach and turn the nuts.

Q:We found an older (maybe 10-15 years) cast iron sink that is 48 inches long with two large basins and a small one in a junk trailer. It has 6 faucet holes drilled like this 0 0 0 on the back and we were wondering what all the holes 0 0 0 were for.

Hot and cold water; the middle one for the place where the water comes out the 4th for instant hot water for coffee or tea ; 5 soap dispenser and 6th for ?? maybe hand lotion?? Or maybe they just drilled the holes in the wrong place to begin with and had to change the placement for the faucets

Q:Home water heater through 6 points of hot water, only three points out of hot water, the other out of warm water. And the location of the hot water and warm water are used together to warm the wall, do a circulating hot water. Whether I am hot water or return water to the hot water is always only a point of hot water, but one of the points of the location of the change

This problem is really the first time encountered. Usually the pipeline is too long, you need to take a long time to solve the water, because the cold water in the pipeline to go out of the reasons. As for your question, since you have found a hot water and warm water at intervals, then you let the plumber turn the basin faucet and the shower into the water pipe down is not the problem solved. If resolved, then it is your hot water separator problem, because you divided the six exports, may be a water separator or you use 3-channel change, then it is a problem. hope this helps!

Q:I've recently seen two movies where they show a sink with two faucets. One on each end of the basin. I'd never seen such a thing. Is one hot and one cold or what? Isn't that a little inconvenient if you want warm?

that was before they made hot and cold come out of the same faucet.

Q:Basin basin faucet and sink faucet with what brand is better?

Hello there! At present the best should be: Kohler. Guaranteed for 50 years