Elevator Wheelchair

Hot Products

Building Hoist SCD200 with Counterweight

Building Hoist Hot Galvanizing Mast Section Sales with 5.4ton Capacity

Building Hoist Mast Section Manufacturer with 4ton Capacity

Building Hoist Hot Galvanizing Mast Section Sales with 5ton Capacity

Building Hoist Construction Handing Equipment

Building hoist SC100/100 Best quality Construction Machinery

High quality hot seller building hoist SC200/200 0-33, 0-46, 0-63, 0-96

Building Hoist Mast Section Manufacturer with 3.2ton Capacity

Building Hoist Sales Galvanizing Mast Section With 33m/min Fixed Speed

Construction Hoist Building Hoist Builder Hoist

FAQ

The safety officer shall be responsible for the work of the construction elevator

(1) the use of dual-use functions of the construction elevator, the installation and removal of the professional personnel issued by the competent department of construction administration shall be undertaken by the professional personnel. The personnel who have passed the training, qualified for the examination and obtained the certificate of the post shall be operated and repaired. (2) the capacity of the concrete base culture cooperation should not be less than 150kPa, the tolerance of 10mm and the drainage facility should be allowed. The distance between the guide bracket of the elevator and the wall of the building should be suitable, and the smoothness should be stable. (3) the lifter is used to control two directions, and the vertical control is 0.05%. Each floor shall have a platform, a passage, a fence and a protective door. No obstacles can be found. (4) the elevator that is installed in a dark place, and the passage shall be illuminated and a floor display lamp and floor number; A closed barrier should be set up in the well. The elevator shall be subject to acceptance by the technical director and the relevant departments, and shall be tested by the crash and shall be used in the rear. (5) in the use of or during the use of the elevators, the manufacturer or designated unit shall conduct the debugging and maintenance and verification. The lifter should undergo a fall test every three months and the fall test should be adjusted when the fall test exceeds 1.2 m. Every time it falls, the receiver should be repaired once.

The construction elevator can only go up can't come down what happened

Does the motor have electricity when it falls? Look at the switch and the line first, then check the controller.

Where is the location of the elevator in the project

Construction elevator location setting, need to take into consideration the situation of the scene and the layout of the building, should consider the following factors: To facilitate the conveyance of material transportation, choose the more spacious rooms in the layout of the floor as import and export; The outside of the elevator is as spacious as possible, with construction channels and materials. The construction materials are minimized in the floor, usually in the middle of the flat. The construction personnel are handy; Monomer building expansion joints at the junction, traffic between unit set up by the elevator capsules export operation platform is completed, so the corresponding reduced floor wall body of the reserved hole lien expansion joints

The tower crane is on a surface with the construction elevator, and only 2 or 3 meters away. Is that allowed

Congratulations, it's a tragedy when you want to start the tower

What about the energy efficiency of the escalator

Construction elevator adopts frequency conversion stepless speed, smooth braking, small impact on the grid, and energy saving effect is obvious, ordinary construction elevator running speed is 36 m/min, motor, 3 * 11 kw; Frequency conversion construction elevator running speed can reach at low speed: 0-46 m/min, motor: 2 * 11 kw, whether in theory or in practical construction, energy saving effect is remarkable, some developed coastal areas in frequency conversion construction elevator as mainstream products has become a trend.

The maximum allowable deviation of the vertical is the vertical degree when the construction elevator is installed

The development of the elevator is in a peak state, because most of the manufacturers or individuals to improve the utilization efficiency of space, more options for multistory buildings, which also need a device to convenient up and down by the goods. Due to the common elevator cost is high, bearing capacity is low, not suitable for carrying dozens of tons or hundreds of tons of cargo, so developed a high bearing capacity of hydraulic lift to assist in the production and transportation of goods. The elevators are both safe and super loadable, and convenient for maintenance, making the special industry grow faster.

When building tall buildings, the machine that USES to lift concrete to wait for tall building

The concrete pump, which can be raised in a certain radius, is the tower crane.

Does the building height not exceed 40 meters must install the construction elevator?

There is no hard and fast rules, but the construction unit according to the time limit for a project, the delivery of materials, construction personnel and management personnel, including supervision, need to install the vertical transportation machinery (including goods dual-purpose ladder).