Q:I just bought the 8800gt, but i don't have the cable to connect it to the power supply.So what cable do i need ??I found those but i am not sure

If you want to find out what cables you need there are two ways. 1. check the manual or guide that came with the device to see if it says what cables you need. 2. take the device with to a hardware or electronics store and ask the clerks there to help you find the right cables for you're device.

Q:What are the cycles and requirements of the experimental project of the power cable experiment?

Two should be phase line, generally in the three-phase loop corresponding to the color: A phase is yellow, B phase green, C phase red, neutral (that is, zero line) for the blue. If only in the single-phase loop only red and green when the default is red for the phase line, green for the zero line. But not necessarily, some electricians do not follow the requirements, the specific you have to use the pen to know what the

Q:I need 600W of power for my new computer, but all I have is 2 300W, 20-pin power supplies. What I'm wondering is if I can combine the 2 20-pin connectors and turn them into 1 24-pin connector?

relies upon on the producer are you advantageous its basically 20 pin as some 4 pin connectors grasp freely so how many different 4 clusters do you have you will desire to have 2 one million of those would be the different connector you go with except its an exceptionally very very old cheappy PSU inwhich case replace it they ordinary and much less costly 30 bux

Q:Allready got 2 1 Tb's external with power cable.Thinking of buying another 1TB, should i go with power cable or not?I was told the ones with Power cable are **** and wont last long :S?I think, that it would perform abit better since its not drainning my Laptops Usb Power?

As okorder /... Both ESATA and USB 2.0. The bomb. My enclosures are all pretty generic. Good luck.

Q:How can i fix it and how much would it cost?

Well... It depends. First things first, never move your laptop with the ac plug connected to the laptop. This is why the plug stopped working. The connection is very fragile, it cannot withstand very much abuse. To get it fixed, you would have to bring it to one of the local computer repair shops to have a new AC jack soldered to the board. You will probably have a hard time finding a larger repair shop that will do this for you. You would be looking at around $120-180 just in labor. The jack will probably run around $10.

Q:The computer is a Hp compaq.So I took the connector out of the computer but left it in the power socket.When I tried to reinsert the connector I hit the metal back panel of the computer and it made contact so I was wondering what is the part(s) that is likely to be broken?I want to know it so I can replace the damaged parts.Thanks in advance of your help.

The power cable should have enough rubber/plasitc to stop contact with power supply directly unless you seen a spark I would try the a different cable. Is the power supply turned on? If it did spark and is turned on try swapping the power supply. Actually I missread, it touched the case itself so now you have to start swapping all parts starting with the power supply, then motherboard if that doesnt work. I hope you have some spare parks around. you could also take out the power supply and you will see a long 24-pin connector you can short the 1 green wire with a black one to see if the power supply turns on. The connector is a cable comming from the PSU not on the motherboard. And lastly each time you try to start the computer after swapping somthing only have the essentials to have it start. No CD drive extra HDD etc.

Q:What is resistance of the cable (resistivity of copper is1.7x10^-8)Answer is 14 ohms. But please explain how do we get there in full detail.

Resistance (R) of a wire is given by: R = ρ.L / A where (ρ) is the resistivity of the wire in Ω.m ; (A) is the cross sectional area of the cable in m? ; (L) is the length of the wire in metres. Radius (r) of one strand = (0.51 / 2) = 0.255 mm = 0.000255 m Cross sectional area of one strand = πr? = (π * 0.000255?) = 2.0428 x 10^-7 m? Total cross section of cable = (12 * 2.0428 x 10^-7 m?) = 2.45 x 10^-6 m? R = (1.7 x 10^-8 * 2000 / 2.45 x 10^-6) = 13.87 = 14 Ω to 2 significant figures.

Q:I can't find out where to put my SATA data cable at... My computer has a SATA power cable though, but I can't seem to find where to put the SATA data cable, I have the data cable in my hand. Can somebody help me? Since I have a SATA power cable in my PC does it mean I can put a SATA data cable in my PC? My PC is a: hp compaq, model: DPS-240EB, if that helps...

yeah that's the power supply not the pc model # StartRunAll ProgramsSystem ToolsSystem Information will list your model # Sata ports are generally brightly colored and look like the ports (blue) in link below caveat: just because the power supply has a SATA connector doesn't mean there's a an SATA port on the motherboard. good luck

Q:I need to replace the power cable for my HF M300, but I'm having trouble finding the proper one. Can somebody tell me what it is I need (preferrably at OKorder)?Thanks!

The power adapter that came in the box is Canon's CA-570. Search for that at OKorder.

Q:i have a 01 grand prix gt and i want to run the power cable to an amp , anyone know a good spot to run it?

if you run your power cable on the passenger side, its important to run your signal cable from your head unit on the opposite side of the car because the signal cable might amplify a hum from the power cable