Rubber Sheathed Welding Cable

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT or LC
Min Order Qty:
3000 Meters m
Supply Capability:
1000 Meters per Month m/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Performance:

 

1.Electric welding cable must have the heat resistance when it works at low voltage (the highest voltage of 200V) current conditions.

2.The long-term permissible operating temperature should be not less than 65°C.

3.Cable should be flexible, good bending performance because that it frequently move, twisted and cast.

4.Cable should require insulated , tearing resistance, Wear-resisting because that it is easily to be scraped and rubed from sharp steel component when it is laying.

5.The environmental conditions of using is complex,such as sunlight, water boiling,cement-contaction,engine oil and acid and alkali liquid-contaction, so it requires certain weather resistance and oil resistance, solvent resistance.

6.It requires good heat distortion resistance Sometime meet heat welding.

7.It requires small external diameter and light weight because of frequent moving.Type YHF has good oil and sunlight resistance as well as flame-retardant properties.

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:SSD power splitter cable question?
Yes it will work just fine.
Q:The power cable troughs are divided once and twice
The function of the cable connector is used for the protection of the cable
Q:installed amplifier power cable to negative on battery, now electrics work but car wont start?
If the electronics work, then it's not the battery, Hooking up the power wire the ground does nothing, there isn't a circuit to complete, without power. Even the remote turn wire, having power, would either put the amp into protection, or pop the fuses...Does it try to turn over? or if not, does it have a starter solenoid?
Q:What is the use of wire and cable per square meter of residential building?
Generally wear SC65 tube. If the distance is too long, elbow and more, then the choice will be larger.
Q:what are the types of cables used in computer power supply, communication between system and its peripherals?
For communication between devices in the computer, such as the hard drive and the motherboard, either IDE or SATA cables are used. For power, Its either a 3 or 4-pin power connector, though some things have two pins (like fan connections to the mother board). Also, the SATA devices use SATA power cables.
Q:surge protector and power filter - monster cable or equiv.?
A power conditioner should be a part of any home theater products you want to keep. Monster makes a fine product and backs it up with a connected equipment warranty. But your issue is not power line noise it is a ground problem, get the cable fixed with the appropriate ground clamps,etc.. If you don't have a monster or one that is equivalent you need to get one. I had a lightning strike, not a near strike but a direct one. Took out everything that wasn't hooked up to a monster power center. A few of those fried but monster replaced them, they did exactly what they were designed to do not pass on a surge or die to prevent it. Calling monster was not a problem, and my replacement centers were there within a few days.
Q:I need a 6 pin power cable. Where can I find one?
You'd need to buy it from your PSU's manufacturer as those tend to be proprietary. It's strange it didn't come with all the cables though.
Q:Is it safe the touch a hooked up 4 gauge power cable when a car is running?
No you should be fine but you should turn the car off and hook the amp up and the positive wire on the positive side of the battery then start it up
Q:what size of power cable?
you can do this 2 ways have a 1/0 gauge wire running from your battery to a distrubtuin block that can branch off into 2 more wires, 4 gauge or 6/8.. and have each wire running to an amp or the same exact thing, except with a 4g wire from the battery to a splitter dist. block running into 2 8g wires.. but i would go with the first way.. will allow better power flow and not have to pull as much from the electrical system... and make sure the in-line fuse is the same rating of all amp fuses together.. so say each amp is a 30a fuse in each make sure the in-line fuse is at least 60amps
Q:what are the power cables on the back of a dell monitor called?
One is the power supply cable (Black one) and since its blue the second one would be a VGA cable. Hope this helps.
We persist in taking "Technical innovation, service society" as development goal, and "quality-oriented, good faith world" as enterprise idea, trying our best to produce heat-supply products. "Creating the maximum value for clients and providing all-round and round-the-clock service" are our lofty missions.

1. Manufacturer Overview

Location Hunan,China
Year Established 2004
Annual Output Value Above US$100 Million
Main Markets Africa 1.26%
Mid East 0.14%
Domestic Market 98.60%
Company Certifications ISO 9001:2008;ISO 14001:2004;GB/T 28001-2001

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department 6-10 People
Language Spoken: English, Chinese
b)Factory Information  
Factory Size: 50,000-100,000 square meters
No. of Production Lines Above 10
Contract Manufacturing
Product Price Range