250w Polycrystalline solar panel stocks for commercial projects

Ref Price:
Loading Port:
Hai Kou
Payment Terms:
TT OR LC
Min Order Qty:
26 pc
Supply Capability:
10000 pc/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Characteristics of Polycrystalline Solar Panel

I Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.

II Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.

III EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV  AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V Junction box: Multi function junction box with water proof.

VI Long lifetime: ≥25 years; Less power decrease.

VII Good performance of preventing from atrocious weather such as wind and hails.

VIII Resisting moisture and etching effectively, not effected by geology. .

 

Standard Test Conditions of Polycrystalline Solar Panel

The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions of multicrystalline silicon Solar Panel, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.

Currently,We have 250w-300w solar panel stocks in Both West and East Coasts made in Vietnam,India,Korea,Malaysia and Japan.Meanwhile,we also arrange production line in Wisconsin,USA.If you're interested,please contact us soon.

Thanks for your time.

 

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Information Regarding Solar Panels?
The manufacturer of any serious panel should be able to provide an efficiency. That will be the STC power rating of the panel, divided by the area of the panel, divided by 000 w/m^2. But the more interesting figure is cost effectiveness, as you say, which is nothing more than cost per watt for the same class of panels. Most applications are limited by money, not by area.
Q:is it worth it to install solar panels?
Solar is mroe expensive than just about every other form of generation for a centralized plant, but can still be cost-effective for a consumer living in the right place. This is because while a coal-fired plant may produce electricity for 2-3 cents per kWh, by the time it's marked up to retail, distributed, and taxed to get to a residence, it may be 5 cents per kWh - a figure which solar can match in many places.
Q:Which is the least expensive, yet still very efficient, type of solar panel?
Since you are asking for a rather technical answer you should be aware that solar panels come in several varieties. Two broad categories are photovoltaic panels which have achieved marketable efficiencies of around 24% and solar thermal panels which are routinely achieving efficiencies of between 60 to 80% while they are also much cheaper than photovoltaic panels. So the short answer is solar thermal panels. But what can you do with solar thermal energy. The answer is just about everything you can do with light energy. Sometimes additional equipment makes the efficiency drop to near that of photovoltaic panels. The trick is to keep the devices as simple and as efficient as possible. Solar thermal can of course be used to heat our homes. But it can also be used directly for air conditioning. The type of air conditioner uses a slightly different principal but it is one of the oldest that was once used in ice houses before refrigerators. It is known as an absorption system. At some point you may want to make electricity from the sun's heat. The most efficient commercial systems are not photovoltaic but solar thermal. There are several commercial systems where increased scale improves efficiency. The most efficient is a solar parabolic dish system combined with a stirling engine. At around 30% efficiency it beats photovoltaic and other thermal systems. At this level of commercial development, the various systems are more often described as solar collectors rather than panels.
Q:Can you get energy at night from solar panels?
Yes. okorder.com/) and informed me of all the incentives I was eligible to receive as well as giving me a break-even analysis, estimated annual savings, and projected return on investment. They are a great resource to begin your solar pursuit. Good Luck!
Q:I NEED HELP WITH MY SOLAR PANEL SYSTEM PLEASE HELP?
I think you need to take some basic courses on electricity. Usually, 8 volt solar panels are required to charge 2 volt batteries. The voltages of photovoltaic cells are set by the material they are made of, only current changes. If you hook up a 2 V solar panel to a 2 V battery, no current will flow, nothing would get charged. You would need some elaborate DC to DC voltage converters to charge a 2 V battery from 2 V solar panels. Solar panels can be connected in parallel or in series, as you've made the mistake of buying 2 V solar panel, you would have to wire them in series and have a charge controller that could limit the voltage of the charge. Did it ever occur to you that two 5 watt solar panels would not be able to provide the power needed by a 400 watt inverter? You're just running off your battery with your set up. Solar power is expensive power, you can not have solar without burning a hole in your wallet.
Q:A more efficient solar panel?
yes it is being done. i've seen adds for such a system. on the other hand, if you had a 5 sq in Lens focused on a small cell, and a 5 sq in cell, they'd be about the same. in fact, the cell might be a bit better because (A) there wouldn't be any loss in the Lens, and (B) it might be that the solar cell would use some frequencies to which the Lens was opaque. in addition, the cost of solar cells is dropping, making the cost of the mirrors or lenses uneconomical by comparison.
Q:Solar panels and your opinion?
Solar power is still an expensive way to purchase power, as of 2007, it was 38 cents per kwh while the cost of power from coal is 0.6 cents per kwh. Of course regulations have prevented new coal power stations from being built so it's really natural gas power stations at 5 cents a kwh that solar has to compete with. Solar is dropping in price but the best you can hope for is for it to reach parity with natural gas someday soon and it hasn't yet. The other issue is that you pay up front for solar power which as any economist will tell you is even more expensive and involves greater risks. However, as part of a strategy to become as self reliant as possible when you retire and have a fixed income, it's a reasonable prospect, not only will the technology become less expensive by then but at that point, fixing the price of the energy costs is more valuable than the cost of the energy. Focusing on personal finance and learning how to invest which very few people know how to do is more important right now. When you retire, hopefully you can afford to build a passive solar home with photovoltaic solar panels and wind turbines but still on the grid for efficient net metering and with a greenhouse where you can grow the staples that you need and perhaps even some biodiesel for your google driven car. Having a reasonable portfolio is really the only way to achieve that goal.
Q:Does a 50W solar panel generate 540kWh?
your first question: Does a 50W solar panel generate 540kWh? 540 kW-hr / 50W = 3600 hours it would take that long for the panel to generate that amount of energy. your second question is confused, as you both stipulate the number of hours at 6 hours per day, and you try to solve for the number of hours. 000 x 50w = 50 kW 50 kW x 6 hr/day x 30 day/mo = 27000 kW-hr/mo = 27 MW-hr/mo that is the amount of energy generated. That is nowhere close to 88240 kWh or 88 MW-hr. I would take 7 times more solar panels to generate that much energy. .
Q:Good Idea To Install A Solar Power Energy On A Restaurant?
To begin with, you need to know how much power you need and then decide from there just how much you can or will have to pay to get that money back. Find a couple companies that do this kind of work to give you some figures to work with
Q:can a l.e.d light power a solar panel?
An LED requires an electric current to power it. A solar panel can most definitely power an LED, but LEDs don't store any power themselves. And solar panels aren't designed to be powered, they are designed to generate electricity. Rethink your premise from the start. It is as if you were asking if the electric wires in your home or community would be powered by the light bulbs and appliances you use.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range