Shower Head From Tub Faucet

Hot Products

FAQ

Kitchen basin basin faucet down how to repair
Look at the leading buds and nuts have broken off? Not broken is the faucet and the bottom of the basin at the bottom of the faucet nut tightened just fine
Xin Si Lai faucet wash basin with a little more on the faucet
You said this brand but also three lines of the brand.
I have a 2.5 bath house. I just noticed the tub at the 2nd bath does not have hot water but the sink and every faucet in the house has hot water. What could be the problem?
there is a obstruction in your bath manifod at the hot side weather it single handle or double handle, the only way to stop the water flowing to the tub is best to shut off your cold where the water enters the house and if you wish shut off the hot at the tank and remove the stem or cartridge which ever it is and possably blow it out with a compressor if you cant see the obstruction which does happen when the water is shut down, when u shut the water down open the hose bib and a couple of handles on your sinks to relieve water pressure
The basin of the basin of hot water pipe is broken, how to replace
Water hose damage, just replace the hose, close the hot water angle valve, with a wrench counterclockwise to loosen the hose connection angle valve hot water pipe hex nut, counterclockwise hose rotation, release hose and faucet The connection thread of the nozzle. If the time is longer, the thread rust, it may be difficult to twist, you can put the hose 90 degrees and then pull. Holding the old pipe to the plumbing store, buy a hot water pipe to re-install it. Note that the end of the hose connection faucet has a long, short head difference. The other end is G1 / 2 of the joints, generic.
Home basin faucet bad, how to replace this? Hand can not reach into the following hose connection, too narrow, is not to remove the basin to replace
Turn off your home water meter. Remove the faucet
Three-hole basin and single-hole basin can be installed single hole faucet it
Can be three holes in the installation of a single hole when you can go to OKorder to buy a rectangular decorative cover can cover the left and right to cover the hole on the exposed hole so that the installation of a single hole faucet up is beautiful!
Into the wall basin faucet from the basin is the height of how much
(1) Before installation, please open the water, remove impurities in the pipe, sand, etc., and then close the water. (2) the flange cover locked into the elbow teeth, and then the teeth wrapped around the stop belt, locked into the strong pipe, adjust the hot and cold water elbow, rotation angle to the flush and the distance and Body hot and cold water hole from the same, then the flange cover rotation close to the wall. (3) the rubber gasket into the body hot and cold water into the connecting nut, and then connected with the hot and cold water elbow lock, please use the 30mm wrench.
Basin basin faucet and sink faucet with what brand is better?
My home is made of stainless steel sink and faucet, Oh, with five or six years, and feel very good. Mainly easy to clean, the quality did not have problems.