Q:I'm changing from a white sink to a SS kitchen sink. The faucet is shiny chrome. The sink has more of a dull brushed finish. Should I get a new faucet or do you think it will look fine? Any answers appreciated, especially if you have done this yourself! :)

thats what I have now and it looks fine

Q:8-inch faucet basin basin can hold 4-inch faucet you do

Can be installed, but a little loose, so the basin basin up and down to install a 4-inch hole with a rubber gasket, the middle also clip an 8-inch diameter, 4-hole hole, the thickness of the basin and the equivalent of Gasket, so that the faucet can be just in the 8-inch hole in the central position.

Q:It slides around constantly. I can even lift it 3/4 inch upwards and see the pipes underneath in their little holes. I have felt under there with my fingers but I don't know what I'm feeling for to try and tighten it. What is the mechanism that tightens it to my sink, and how do I go about fixing it?

you need to get a flash light and get inside the cabinet...just be care full because any loose rust will fall into your eyes...there is probably 1 large nut or 2 smaller nuts they need to be tightened up...its not uncomon on old faucetts for it to rust away and not even be there any more...you may need a special wrench (basin wrench) to get up there

Q:It's very important that I do this the right way. (I sort of told the people I was working with that I knew how....but I don't) I bought a new faucet from Lowe's, and it has instructions on the back but I think I'm missing something. They also said something about the plumbing being bad and hard to work with? I've never done any kind of plumbing in my life.

do you need a ptrap for the replacement snk

Q:will connect to vintage tub basin connected to pump.

Have a blacksmith create one for you.

Q:I removed the faucet assembly from the bathroom sink/basin to replace it with a new one and it's completely yellowed underneath. It's not as bad as it was after I tried to clean it with the rubbing compound I would use on my car but still not gone.I have to get it all cleaned away because the new one is not the same shape at the base as the old one.Anyone here had experience with this and know the best stuff to use?

Chances are its from the pipe dope or plumbers putty that was used. Treat it like a greasy stain and use some baking soda, some cleaner like Greased Lightening or Blue Wolf. You can also try putting some hydrogen peroxide on it over night and covered with a rag or some plastic if its not granite or marble. Should clean up fine then. Good luck!

Q:Wash basin faucet how to change the hose

6, the threaded tube screwed into the lower side of the container, the top of the container on the silicone pad at this time can be placed on the lower side of the faucet. 7, nuts fixed faucet, the nut can be tightened, the installation is complete.

Q:Wash basin sets of faucets on the combination of how high to set aside

General washbasin table height of 80 cm, faucet than the table height of about 5-10 cm can be.

Q:I just wanted to replace my kitchen sink but now that we have it in my cold water hose wont fit into the cold water valve.. they are both female ends. is there an adaptor i can use? do i have to replace the valve with a valve that has the right connection? and lastly what are these parts all called so i wont look like an idiot at the hardware store. thatnks for the help every one!

Please okorder , or the like) I can't tell what valve you're referring to.

Q:Wash basin faucet is too low, can not shampoo how to do

The faucet is too low, only a little higher taps, no other way.