Commercial Roofing Systems

Hot Products

FAQ

Gypsum board after the ceiling how to brush white ah?
Gypsum board ceiling: 1, the use of light steel keel according to the design requirements, or modeling or put down the light steel keel, 2, the gypsum board with self-tapping screws fixed on the dragon skeleton, 3, oil workers use anti-rust paint will be fixed by a point brush, 4, the use of elastic putty gypsum board and gypsum board patchwork (installation of gypsum board, the patchwork must stay 8-10 mm gap) leveling, naturally dry. 5, with a special gypsum board sealed with a latex paste paste in the gypsum board and gypsum board patchwork, naturally dry. 6, and then putty after 2-3 times leveling, grinding process until the smooth and smooth, 7, brush the first series of latex primer, naturally dry. 8, in the rolling brush 2-3 times the latex finish can be.
Gypsum board ceiling installation corner must be seven-shaped
You should say is mineral wool gypsum board bar (specifications 600 × 600 or 600 × 1200), the corner must be used piece "L" type, or take the sub-bone and edge aluminum. Norms also have this requirement.
Gypsum board used in the expansion agent
Gypsum board foaming agent for the gypsum board in the production process gypsum foam.
Ready to decorate, will the sauna board ceiling and gypsum board ceiling, the price of the two?
Of course, is to use the sauna board to do the ceiling, the cost is higher ah
I installed the lights on the gypsum board on the screw, not the kind of embedded lights
Looking for gypsum board ceiling when the position of the dragon skeleton, in the position of the keel installed lights, and now the lamps are relatively light as long as you can screw the screw on the keel it certainly no problem.
Gypsum board brush latex paint how to deal with yellow
Directly on the gypsum board (plate) on the latex paint is easy to fall off and yellowing phenomenon, we must first primer, it is recommended to use the home of the board of people worry-free putty (TB), to be dry and then approved scraping putty Powder in the brushing latex paint.
Causes of Cracking of Gypsum Board Ceiling Joint and Its Treatment
The original gypsum board water, and then evaporate, the natural will shrink; so when the brush finish two or three days is not obvious, but two weeks later a problem.
Gypsum board can not tile?
Gypsum board is generally not tiling. The bottom can also use the cement pressure plate can be directly above the cement mortar tiles; can also use glass magnesium board (also known as magnesium oxide board) above with cement mortar can be posted but I do not recommend using cement mortar because of bad, then easy to fall , If the bottom plate with glass magnesium I recommend the use of AB glue paste tiles, but the cost is relatively high (AB glue expensive).