Calcium Oleate

Hot Products

FAQ

Ceiling, shape the same, with gypsum board is good, or with silicon calcium board material is good
Home decoration ceiling 99% with gypsum board, but the gypsum board points good difference.
Fiber reinforced calcium silicate board is to do with the cut off it?
Industrial and commercial construction of ceiling ceilings and partitions, home decoration, furniture liner, billboard liner, ship compartment board, warehouse floor, network floor and tunnel and other indoor works of the wall.
The difference between calcium silicate board and plywood
Plywood do not know the amount, but with the use of adhesive resin is certainly not environmentally friendly, there is no fully resistant to aging organic resin
Calcium silicate board sticky rock wool sandwich sandwich board what glue stick to live?
This problem is very good solution, ah, with MPU-20-type one-component polyurethane adhesive can be bonded.
Calcium silicate board how to deal with smooth surface, that is, I would like to foil in the calcium silicate board, is to be very common to paste the bottom,
The first lower number of sand belt sand flat, and then a high head of the belt polishing, pits or wood fiber fluff easily blistering, you can try or ask the belt or sanding equipment manufacturers
Calcium silicate board production line
The method of copying is to flow the prepared slurry into the cage through the slurry tank, and the slurry is submerged to about 3/4 of the diameter of the reel, and the outer ring is wrapped with a certain number of internal and external networks. The upper part of the wheel set with a roll of blankets and blankets in contact with the wheel, running, the chest roller rotation to drive the blanket running, the passive roller rotation while driving the rotation of the wheel, the slurry in the role of pressure through the reel filter, Layer attached to the net outside the net, because the net is a porous and can be through the air, and the fog roll, blanket and material layer between the more dense, no air can be passed, so the material layer more easily from the reel to the wool , Thin primary layer was continuously passed on the blanket. The stirrer is used to prevent the slurry from settling, and the heavy sand debris sinks to the bottom of the tank and is periodically removed by the release plate of the floor. The material layer through the vacuum box after dehydration, winding to the forming tube, to achieve the required thickness from the molding tube after pulling off the wet blank, the next process into a variety of products.
How to distinguish between the color of calcium silicate board is good or bad
Identification of calcium silicate board with fire: Calcium silicate board is a fire board, so the direct use of a well-burned plate, then there is no role. Before the fire must use the way to get the plate, pay attention, do not directly use the saws saw, if it is thin, hand directly snapped, if it is thick plate, use the hammer to break it. After the break, you will send now cross-section inside covered with small lines, these small lines or that is asbestos, or that is the plant fiber, if it is asbestos, then burned after the announcement will affect the burning smell, If it is plant fiber, then burned after the paper will announce the taste of burning. A smell can easily distinguish this calcium silicate board is not rich in asbestos.
Calcium silicate board is not keel, you can directly nail on the wall?
No, the same dragon skeleton. If you do not have a direct steel wall keel, directly with a wooden keel on it