1.5 V Lithium Battery

Hot Products

FORKLIFT SERIE - DIESEL FORKLIFT - CMAX

22000-36000 LB CAPACITY DIESEL PNEUMATIC TIRE

The durable 80-volt 2EPC7000-2EP11000 Series of lift trucks

15500 LB capacity diesel pneumatic-mexico

lift trucks GC35K-GC70K STR Series provides maximum performance

electric cushion tire lift trucks,4,500-6,500 lb. Series

FORKLIFT SERIE - BETTERY FORKLIFT - CMAXFE3R08AC

gas cushion tire lift truck,3000-6500 LB capacity LP

FORKLIFT SERIE - ELECTRIC FLAMME PROOF FORKLIFT - CMAX15-20

FORKLIFT 2,500-4,000 LB CAPACITY 3-WHEEL PNEUMATIC TIRE

FAQ

What's the difference between a forklift?

Is a kind of special equipment operation operation certificate issued by the municipal pledges inspect bureau, a green book, the project may not write forklift 2 words, write the code N2 (on behalf of the forklift truck), the enzyme, called operation certificate, necessary to mount guard. Another kind is people club bureau (former labor bureau) issued by the vocational qualifications, junior, senior, this card is used to assess technical level of workers, country or large enterprise to review salary.

What if the forklift oil is burned and the oil is burned

First open the hood, and pull out the distributor of the central high tension line, from the cylinder block there is 6 or 7 mm, switch on the ignition switch, turn the crankshaft, view the high tension line to produce edm. If there is no spark, there is a fault in the low voltage circuit with short circuit, broken circuit or ignition coil and central high voltage line. Interchangeably disconnecting, closing contact, observing the meter pointer reading. If the current meter instructs the discharge 3 ~ 5A and the intermittent oscillations, the low voltage circuit is good, the fault occurs in the high voltage circuit. If the current meter pointer does not oscillate, it indicates that the low voltage circuit is broken. If discharge of large current of electric current meter, indicates that there is an iron failure in low voltage circuit. If the spark is too strong, it creates a blue and white spark. The low voltage circuit and the ignition coil are good, the fault is in the distributor and the spark plug high voltage circuit. From the top to remove the high tension line head, spark plug rocking-turn crankshaft to the body tries to fire, such as no fire should check the distributor rotor, distributor cap, and whether high subsection line leakage, is when the spark ignition timing shall be checked and the performance of the spark plug.

What is the safe speed of the forklift truck

In factories, cars are typically limited to 5km/h, which is not a requirement for companies.

The forklift truck can't be combined for a license

According to relevant national regulations forklift truck, forklift, excavator operations must hold relevant certificates, need special operation operation certificate (also called special operations IC gets stuck), in the local safety bureau is dealt with; The forklift truck can't be used as a license because the excavator belongs to the engineering machinery; Forklift truck is a logistics machine, different industry.

Hydraulic forklift and what hydraulic oil

Winter 46 # hydraulic oil summer 32 # hydraulic oil In the summer, you can use the 668 # hydraulic oil for the summer

Diesel forklifts generally take a long time to replace the oil

Run 150 ~ 200 hours for oil change..Normally, the oil and oil filter will be replaced in about 200 hours.

What do you mean by the center spacing of the load on an electric forklift?

Load center distance In short, it means the center of gravity of the cargo. For example, the length of the fork is one meter, and the center of the load is half a meter away. In turn, the 1.8-meter-long cargo fork, the center of the payload is 0.9 meters away. It is dangerous to use a one-meter fork fork, which is 1.8 meters long, and the center of mass of the cargo is at 0.9 meters. It's likely to fall!

What is a forklift for?

Forklift plays a very important role in the logistics system of the enterprise, it is a very important component in logistics, it is the main force in the material handling equipment. Widely used in the national economy, such as station, port, airport, factory, warehouse, etc., it is an efficient equipment for mechanized loading and unloading, stacking and short distance transportation. Self-propelled forklifts appeared in 1917. During world war ii, forklifts were developed. China started making forklifts in the early 1950s. Especially with the rapid development of China's economy, the majority of enterprise material handling has been out of the original manual handling, instead of forklift truck is given priority to the mechanization of handling. As a result, demand in China's forklift market has grown at double-digit rates every year for the past few years.