universal frame wiper blade
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- 500000 pair/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
You Might Also Like
1. 100% natural rubber to suit different weather around.
2. Quality spring to assure longer life.
3. New locking system for quick and easy installation.
4. Fancy design and exquisite techniques to give you difference and dignity.
5. Applicable for climates world
6. size available: 11"---24"
- Q: I have a 1998 Ford Explorer XLT. I just had Ford replace all 3 of my wipers. They told me that they do not make wiper inserts and the entire arm must also be replaced. My windshield wipers are fine but my rear wiper still skips about 50% of the window (right in the middle.) I thought that if they replace the arm this would be fixed. So did they scam me, and only replace the inserts or is this another issue?
- bending it might help a little, but it sounds like the internal spring has sprung and not keeping it against the window. It is inside the window arm
- Q: I have a rondave and the windshield wipers are only wiping half way how do I fix it
- It could be the wiper motor. Now if it comes back down and hits the car, it could be the wiper arm. If you had the arm replaced or taken off for some reason it could not be set right. If you done none of that it's most likely the wiper motor going out. Both are easy to do, just look it up on YouTube under your car.
- Q: my 05 chevy aveo‘s windshield wipers have always jumped of the window while driving at high speeds (like highway speeds) when they were on. Now they are missing an increasingly large amount of the middle of the windshield whille they are on. I was debating on repacing the drivers side arm, but will it make a difference since it always did it a little? The only place I can get the replacement part is at the dealers, so won‘t it be the same part as before?
- Always on the front of the car for front wheel drive
- Q: do i just replace the motor or.is there something connecting. hmph
- On 1995 sentra there are separate parts available for your wiper transmission (yes transmission) on the wiper motor there is a crank with ball studs that turn in a circle a flat metal rod with two bushings transmits motion to the other wiper blade shaft where there is another lever with a ball stud. Ice on the window rusted solid wiper shafts can cause the rod to pop off the wiper transmission ball studs. Some cars have two wiper transmission rods one between the wiper shafts and another from the motor to the wiper blade levers. (note) the new rods are super tight and snapping them on may need a C clamp and some cussing. Good Luck
- Q: How do i remove the windshield wipers on my 1990 cadillac Deville? pics would be great. thanks
- thank you for the advice approximately RainX. I even have been given my vehicles' oil replace some month in the previous. They study for each little element, which contain windsheild wipers.My automobile is a 2009,and that i could desire to determine the wipers greater many situations via certainty the warmth temperature of the summer down the region I stay , makes the wiper blades wreck quicker.
- Q: Why do the windshield wipers on my 1999 Mercury Sable LS come on by themselves?
- your wiper switch at the end of your turn signal is bad. Mercury Sables do not have rain sensor wipers its a bad switch.
- Q: My windshield wipers are stuck in the upright position on my 2001 Pontiac Montana and they wont return to the right position. They work fine when I‘m using them, but when I turn them off they return to the upright position. I took out the fuse, and that is not the problem. Any ideas on why they would stay that way and any suggestions as to how to fix it would be great.
- Well there is a sensor that tells the motor where to stop and that could be faulty also the wire going to it could be bad , the sensor is on the wiper motor or built into it. What I'd do is go to a U pick auto wreckers pop out another wiper motor for about 10 to 20 bucks,or buy the whole wiper motor and linkage assembly and switch them , or just get the motor and unplug your wiper motor try just plugging in the used motor , run the wiper motor see where it stops , compare it to the wiper motor on the vehicle , you might need to remove the grill and wiper arms to get a close up look and check when it's plugged in and stropped where it's arm stops. Hope that helps and best of luck.By the way it more then likely is the wiper motors stop position sensor.
- Q: Where are the relays for the windshield wipers located? The wipers turn on by the switch but will not turn off unless you turn the ignition off. The dealer said there are 4 relays and one or more are bad
- Remember the guy that told you about the relay problem? Ask him.
- Q: 2005 MaximaSometimes windshield wipers turn on and it happens a lot more in warm weather. Everything else in the electrical system seems to be working find. The dealer wants to change something called IPDM and charge several hundred dollars which I am not ready to do. Any other ideas?
- Let me check that circuit. Yes I would have to agree with your dealer. The IPDM is located on the right side of the motor compartment under that plastic cover and another plastic lid with the fuse designations on the side When the wipers are running wild with rap on the IPDM with a Screwdriver Handle. Nissan Shop Manual I looked at it appears that the switch inside just talks to a CPU inside the IPDM and that device turns on wipers washers with relays for each speed. IPDM powers lots of other remotely operated electrical devices. IPDM is retangle shaped 1 1/4 inch thick with about 20 fuses and 15 black relays and 6 power wire sockets with lots of wires each. IPDM has two catches on each side and pull straight up. Get one out of a wrecked car but you must know that the trim level on the wreck is the same SL to SL SE to SE and LE TO LE. Things like cornering lamps HID headlights auto sunroof ECT. Different on different trim level cars. Good Luck
- Q: wipers act erratic, sometimes they work fine, other times not at all, even when i manually coax them.
- That was a problem with GM trucks all the way through '98. I had a '96 that did the same thing. I found with mine if you put slight pressure on the wiring harness it seemed to fix the problem, so I just loosely zip-tied the harness to the wiper motor bracket so it kept pressure on it. It worked without failure until I sold the truck two years later. It may work on yours, or it may not. If not, all your out is a five cent zip tie. As previously mentioned they had a circuit board problem.
Send your message to us
universal frame wiper blade
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- 500000 pair/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
Similar products
Hot products
Hot Searches
Related keywords