QY75E Truck Crane
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Brief introduction
Equipped with the longest boom among like products, reliable hydraulic security device and the imported variable
pump, valve and lock, and the electric proportional control system as well as the energy-efficient truck crane chassis, QY75E truck crane lifting performance outperforms its competitors. PLC control technology is applied to electrical control
system and makes it much simpler, more stable, reliable and durable. Its appearance embodies the brand culture of Beijing Jingcheng Heavy Industry Co., Ltd and is the symbol of high quality.
Specification
Max. rated capacity | 75000 kg |
Max. traveling speed | 75 km/h |
Gradeability | 40% |
G.V.W. | 45930 kg |
Front axel load | 19930 kg |
Rear axle load | 26000 kg |
Min. turning radius | 12 m |
Main boom |
|
Section | Five - section U |
Length fully retracted | 11.8 m |
Length fully exended | 45 m |
Telescoping speed | 135 Seconds |
Elevation speed | -2° to 81°:70 s |
Jib | Two sections articulating jib, equipped with a one - way pulley at boom end |
Length | 10 m and 18 m |
Hoisting system | Variable speed hoist with double grooved drum and anti-swing wire rope; |
| Variable-displacement motor,proportionally control the speed of the hoist; |
| Main hoist is equipped with built-in normally closed brake and balance valve. |
Line pull | 61.25 kN (6,250 kg) |
Line speed | 130 m/min at the fourth layer |
Wire rope | Diameter···20 mm |
| Length···230 m |
Outriggers | Four H-type hydraulically controlled outriggers; Independent horizontal and vertical movementcontrolled form each side of carrier and the superstructure cab. |
| Each outrigger is equipped with hydraulically controlled check valve. Electronic crane level indicators. |
Outriggers footprints | Horizontal·······7800mm |
| Longitudinal·······6000mm |
Chassis manufacturer | JCHI |
Chassis model | Overall width cab 8×4 |
Engine |
|
Model | ISLe37540 (or35) |
Type | 6 cylinder in line, common rail |
Displacement | 8.9 L( Tier IV / National III ) |
Rated poer | 276 kW / 2100 r / min |
Max. torque | 1550 N·m / 1400 r / min |
Gearbox | 16 speeds forward, 2 reverse |
Slewing system | 1.7 r / min Free slewing |
Hydraulic system |
|
Hydraulic pump | Tetragenous gear pump driven by engine through P.T.O |
Control valve | Multiple control valves actusted by pilot pressure with integral pressure relief valve |
Hydraulic oil tank | Capacity :823 L |
Oil filter | Return oil filter |
Safety devices | Relief valve |
| Hydraulic lock |
| Working range and load indicator |
| Overwinding auto control alarm |
| Counter balabce valve |
| Load indicator |
| Height limiter |
| Overwinding control alarm |
- Q:Is the truck crane and truck crane mean?
- and the crane is only used to unload the goods on the carriage, usually installed in the car between the cab and compartment, the largest lifting capacity Only about 3 tons
- Q:What are the shortcomings of a car crane?
- Crawler cranes get off without cabs, driving operations and lifting operations concentrated in the car control room
- Q:The world's largest car crane can be heavy?
- Seven main arm up to 84 meters, the arm up to 63 meters, the total length of the crane close to 150 meters
- Q:Is the truck crane limited by the yellow mark?
- Car crane in the final analysis, or motor vehicles, subject to the yellow standard.
- Q:Is a car crane a car crane?
- Truck crane chassis performance is equivalent to the same vehicle weight of the truck, in line with the technical requirements of road vehicles, which can be unimpeded on all types of roads.
- Q:How to determine the weight of a car crane
- Of course, large tonnage of the activities of the weight will be marked, because it needs to enter the conditions and then hoisting, input conditions after the computer will prompt you to have several configurations can be completed hoisting, you can choose their own.
- Q:What is the principle and purpose of the rotary joint of the truck crane center?
- There is no hydraulic principle, is a simple principle of mechanical work!
- Q:What is the material of the truck crane wheel?
- 2, nylon pulley material for the engineering plastics - nylon-made crane pulley has a good technical performance, about to improve the life of the pulley 4 to 5 times and wire rope life 10 times.
- Q:Do you need a harness for a truck crane?
- because the road when driving on the car is not able to sit; get off, and ordinary truck chassis is almost the same
- Q:How does the car crane (wheeled car crane) overturn insurance claims?
- If the purchase of vehicle loss insurance, car cranes (wheeled car crane) overturned losses caused by the insurance company is responsible for compensation 85%
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
QY75E Truck Crane
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
Offcanvas right
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords