Q:Toilet wash basin from the ground should be how high

The floor of the floor is 750mm ~ 800mm

Q:how do i remove the faucet from the delta 1400 series faucet?

After turning off the water and disconnecting the water lines there are two PVC or metal nuts underneath (under the sink) the hot and cold water valves that once removed will free the faucet from the sink.

Q:Why the two-hole basin faucet center distance is 102 and GB size is 150 ah?

If the distance between the basin is 102 mm there is no problem, the market to find the leading to match.

Q:I removed the faucet assembly from the bathroom sink/basin to replace it with a new one and it's completely yellowed underneath. It's not as bad as it was after I tried to clean it with the rubbing compound I would use on my car but still not gone.I have to get it all cleaned away because the new one is not the same shape at the base as the old one.Anyone here had experience with this and know the best stuff to use?

Chances are its from the pipe dope or plumbers putty that was used. Treat it like a greasy stain and use some baking soda, some cleaner like Greased Lightening or Blue Wolf. You can also try putting some hydrogen peroxide on it over night and covered with a rag or some plastic if its not granite or marble. Should clean up fine then. Good luck!

Q:Home of the newly renovated toilet basin with the kind of shower that can be out of the kind of leading brand is the Hanshin but the water is very small, shower faucet and kitchen faucet out

Newly renovated look for business repair, or change a new one

Q:Im installing a new kitchen faucet. I have disconnected all hoses and the sprayer from the kitchen sink. I have disconnected the handles and stem.My problem is Im not sure how to remove the two washers directly under the sink handles for cold and hot. Once I get them off I should be able to remove the remaining locking nut on each side.Any suggestions to get these rusted pesky washers off?I have the following tools at my disposal:Basin WrenchPliersScrewdriversDrillDremel Rotary ToolSmall ChiselHammerMallet (Metal and rubber)plus pretty much any other basic tools.Any help much appreciated.

try and cut through the plate from up above do you have a sawzall? When you get through bend the plate from middle cut with small chisel or flat screw driver and you should be able to cut through the rusty bolts good luck

Q:the tub has deminsions of 12' long 6' deep 4' width -how ong will it take to fill up?

This is extremely confusing

Q:Understand basin faucet installed?

Pre-installation: Before installation, please check the installation hole template, pencil, glue (such as vigorously glue), fastening plywood (such as two fingers wide marble block), faucet, soap dispenser and other options are ready

Q:It is better to wash the faucet

Can pull the basin faucet, easy to wash your hair, but also easy to wash the basin, items and so on. But life is not as good as ordinary basin faucet long. Must be selected when the purchase of good quality.

Q:How is the detachment of the Crowe basin?

Still can not be demolished, you can brush some kerosene on the screw, so that kerosene soaked into the screw (about 2-4 hours) after the demolition; can not be removed to the faucet, the faucet can be cut off