Q:How is the center of the processing center?

Use the edge finder to install the edge device and then MDI mode input S500M3; sure to confirm the speed and then start there will be life-threatening if more than 0 input S5000 did not pay attention to the edge of the edge of the direct rejection of the consequences are very serious!

Q:The difference between the heart and the milling machine, I feel like almost! Is not the diameter of the processing machine to be smaller?

Simply speaking, take the heart of the lathe tool does not move, the spindle with the workpiece to do interpolation movement.

Q:Does the OKUMA Machining Center be the name of the machine or the system used by the machine?

OKUMA machining center is the system used by the machine.

Q:Machining center fault problem!

414 Servo alarm: Z axis detection

Q:Will fanuc processing center length compensation how to use? Can you give an example to explain!

The first knife after the knife in the data in the G54 Z-150 and then into the knife fill H1, enter -150.

Q:What is the use of the G94 command?

After using the G94 command, all feeds are in units of mm / min, ie F100 means that the tool moves 100 mm per minute (the default)

Q:Processing center intermediate workers, senior workers, to the technician, how to test, what are the requirements?

You can go to the local processing center vocational qualification qualification of the identification station or go to the local vocational appraisal center registration.

Q:CNC machining center g51 scaling instructions. Suppose I'm a 20-round round Now I want to shrink to 10 rounds how to use this command. Such as

Instruction format: G51 X____ Y____ Z____ P____

Q:Processing Center Apprentice

But if you want to learn the operation, then it is recommended that you do the processing of parts and parts of the machinery factory where to learn a lot of things because of things in the mold factory, then you do the machine is up to pull the straight line of the school center only

Q:Processing area of the processing center

complex surface class parts complex surface can generally use the ball head cutter for coordinate processing, processing accuracy is higher, but the efficiency is low. If the workpiece exists in the processing of interference area or processing dead zone, we must consider the use of four coordinates or five coordinate linkage of the machine. Such as aircraft, car shape, impeller, propeller, all kinds of molding die.