Q:Acting as pneumatic component 60I've been selling pneumatic parts for three years

Nowadays, there are too many brands of pneumatic components, such as low-end brands, the price must be competitive

Q:What are the common pneumatic components?

Cylinder, solenoid valve, air source processor, auxiliary component

Q:What is a pneumatic major?

To train technicians, hydraulic, pneumatic equipment installation, debugging, maintenance and other technical management work, and general mechanical, hydraulic and pneumatic system design ability of high-level technical application talents

Q:What are the advantages of pneumatic components?

5, the use of compressed air, storage energy, to achieve centralized gas supply. It can release energy in short time to obtain high speed response in intermittent motion. Buffer can be realized. Strong adaptability to impact load and over load. Under certain conditions, the pneumatic device has the ability of self preservation.6 、 all pneumatic control, with fire prevention, explosion proof, moisture-proof ability. Compared with hydraulic method, pneumatic mode can be used in high temperature situation. 7, because the air flow loss is small, compressed air can be centralized supply, long-distance transmission.

Q:How much is the dynamic pressure gas picks

Most of the work pressure on the use of pneumatic equipment in the industry is about 0.55Mpa. (i.e.: 5.5kg/cm2 or so).

Q:Main points of type selection of pneumatic control valve

For pneumatic pipes, a little leakage is allowed, and the leakage of the hydraulic pipe will cause pressure drop and pollution to the environment.(three) the requirement of lubrication is differentHydraulic system of the working medium for hydraulic oil, hydraulic valve does not exist on the lubrication requirements; pneumatic system of the medium of work for the air, the air is no lubrication; therefore, many pneumatic valves need oil mist lubrication. The valve parts shall be made of materials which are not subject to water corrosion or take necessary rust preventive measures.(four) the pressure range is differentThe working range of the pneumatic valve is lower than that of the hydraulic valve. Pneumatic valve working pressure is usually less than 10bar, a few can reach less than 40bar. But the hydraulic valve has high working pressure (usually less than 50Mpa). If the pneumatic valve is used under the maximum allowable pressure. Accidents often happen.(five) the use of different characteristics;General pneumatic valve than hydraulic valve structure compact, light weight, easy to integrated installation, valve work frequency, long service life. Pneumatic valve is in the direction of low power and miniaturization. Low power solenoid valve with 0.5W power has appeared. With computer and PLC programmable controller connected directly, can also be installed on a printed circuit board with electronic devices connected through standard gas electric circuit board, save a lot of wiring, suitable for pneumatic manufacturing assembly line of industrial manipulator, complex etc..

Q:I would like to ask you, pneumatic components, including what mechanical parts?

Pneumatic components mainly include gas source treatment (triple parts, filters, pressure reducing valves, etc.)

Q:What is the difference between pneumatic components PC8-03 and PC8-02?

Do you mean the connection? If it's the joint, 02 refers to PT1/4, and the 03 refers to the PT3/8, the joint is one side of the pipe and the thread, and the two are inserted into the 8 pipe

Q:What hydraulic and pneumatic components are used in the printing machinery industry now? Please give me more details

Throttle valve, etc.. If advanced, "proportional control valve" will also be used, but very few.

Q:What about leakage of pneumatic components?

But as long as the cylinder is removable, there are basically standard sealing components can be replaced.