Stratoflex Hose Fittings

Hot Products

Polyethylene raised temperature resistance (PE-RT) for floor heating

0.4MPa dn20-1600 HDPE80 Water supply Pipe

Rubber Silicone Hose Colorable

Modified poly vinyl chloride(PVC-M) pipes for water supply

High Pressure Rubber Air Hose High Temperature for Autoparts

Standard:GB/T5836.1-2006 PVC-U drainage and sewage pipe in buildings

Garden Water Rubber Hose Good Quality 5''

PVC-U electrical insulation conduits and fitting in buildings

0.4MPa/0.4MPa/0.6MPa/1.0MPa PE pipe for gas pipe

High Pressure Rubber Fuel Hose High Temperature 3 Steel Layer

FAQ

Difference between non-standard rubber joint and national standard rubber joint

GB and non standard. GB type rubber joint refers to the material selection and production in accordance with the relevant 02S404 or 02S312 standards of the Ministry of construction, and has strict requirements on flange thickness, flange thickness, diameter and thickness.

How to make sure the rubber hose will not be worn off?

The sole judgment is as follows at the end of the rubber bottom or tendon tendon end methods: look at the color, color is usually translucent, while the rubber bottom is not.

How far is the gas cooker from the gas riser in the kitchen?

Rubber pipes shall not be worn through the chamber and should be checked regularly. It is found that aging and damage should be replaced in a timely manner (rubber tubes shall be used for a period of not more than 18 months).

HDPE double wall corrugated pipe joint shall be made of elastic sealing rubber ring and socket joint interface. What are the requirements for rubber ring joint?

When the interface is made, the inner wall of the bearing mouth is cleaned first, and the lubricant is coated on the inner wall of the socket and the rubber ring of the socket, and then the central axis of the socket face end is aligned.

How can the rubber pipe leaking from the cold water inlet of the electric water heater do?

Estimation is inside the pipe aging cracking due to Water Leakage, no maintenance necessary, unless it is a joint sealing ring in aging can replace the sealing ring of new or with rubber or other flexible items I cut a replacement.

Why does Br2 corrode rubber tubes?

Bromine elements need to be sealed with water to prevent steam escaping and harm the human body. Oxidizing, there are a variety of variable valency, under normal temperature and weak water reaction, generating hydrobromic acid and bromate. Heating increases the speed of reaction. Hydrobromide is a strong acid with an acid stronger than that of hydrogen chloride. Bromine is commonly used in organic synthesis.

What happened to the soft rubber flat?

The two above are all correct, this is mainly to see where you are used, and if used in the settlement of the joint or expansion of the above, and then appear flat, then it is easy to burst the tube. It is important to note that metal bonding is recommended. Rubber joint is commonly used to shock, is not recommended when the expansion joints, expansion joints when used, if appear flat phenomenon, prone to pull off the situation (is flange off). The danger of exploding pipes everywhere. So it's not that rubber joints are bad, and it depends on where they are used.

Will the electric water heater be well connected with metal hose or hose?

The electric water heater, now in the industry are required to use PPR on the inlet and outlet pipe welding, a long service life, can effectively control the water heater outlet Water Leakage; on the other hand, can avoid the water heater power switch for two grounding and frequent take-off effectively. Therefore, the metal pipe connection does not meet the safety and installation specifications