Hot Products

FAQ

How to remove the peculiar smell of rubber products?
Boiled smell removing method has a long history, has already appeared at the end of 80s, now there is also a part of the factory workshops in using this method (the rubber products produced by cooking in boiling water) this method can eliminate the small part of the reclaimed rubber smell, but most can not eliminate and cannot be eradicated, after a period of time reclaimed rubber continued precipitation and volatile flavor. Boiling water with the exception of flavor, artificial high cost, cumbersome process, the effect can not be sustained, and go to the general effect of flavor.
How to enhance the performance of water resistant silicone rubber products
In general, silicone rubber is almost free from the influence of free steam and moisture without pressure. The same is true when the steam is under low or moderate pressure. However, as the vapor pressure rises, the impact on the mechanical properties of the rubber becomes larger. Therefore, silicone rubber is not recommended for long-term use in situations where steam is more than 50psi.
What about the smell of smoked rubber products?
The corresponding type of rubber deodorant is one of good methods for removing it, or to reduce the degradation of various rubber acids produced in the processing or in the process of the use of alkoxy compounds, aldehydes, vinyl compounds, peroxide and sulfide odor of chemical additives, the smell if inhaled for a long time will stimulate the senses, give people uncomfortable feeling even harmful to the body, have two times of pollution to the environment, the chemical composition of different varieties of rubber and the resulting odor molecules are different,
Doors and windows shock absorber seals, rubber blocks, rubber products, do not know where to buy, where suppliers?
The product has good elasticity and anti compression deformation, and has excellent aging resistance. It adopts the microwave vulcanization process to form at one time. The surface is smooth and beautiful, without any trace.
PVC conveyor belts and rubber belts differ from each other in their respective advantages
Rubber belts are widely used in conveying equipment, but do you know that proper vulcanization of rubber can maintain high elasticity of rubber and make rubber of a certain strength?. At the same time, in order to increase product hardness, strength, wear resistance and tear resistance, while adding inert filler in the process (such as Zinc Oxide, clay, chalk and barite etc.) and reinforcing filler (such as carbon black), which helps to improve the quality of the conveyor belt.
How to make rubber products keep brightness for a long time?
Rubber products should be painted with rubber bright oil, in case the rubber formula is designed, the product is shiny and the oil is not sprayed.
What about rubber molding, foaming and layering?
Foaming1 vulcanization is not sufficient, the temperature is too low or time is too short, so that the volatile compounds produced during curing have not been cleaned out;2, under the pressure of vulcanization, the trapped gas and sulfur volatile matter can not be discharged in time3, there is air or moisture in the glue;4, curing temperature is too high, the surface of the gum material premature vulcanization, hindered the glue material in the steam, air free precipitation5 vulcanization speed of material is too fast
How does the rubber part of the watch become yellow?
The rubber strap is yellow and rubbed with the weld polish. Remember, the ratio is 1 to 70.