Laminated Flex Banner
Specification of Laminated Flex Banner
Suit for solvent base inks
Features of Laminated Flex Banner
1. Glossy and Matt style available
2. Weather resistant (UV, rain, typhoon and frost)
3. White substrate for wide format digital printing
4. Applicable to Vutek, Scitex, Nur, Infinity, Flora printers
Application of Laminated Flex Banner
2. Exhibition booth decoration
3. Displays (indoor and outdoor)
4. Building murals and instore displays
- Q:Maintenance time of the cushion on the roof of the building
- According to the "concrete structure construction quality acceptance criteria" provides:
Concrete should be poured within 12h after the completion of the concrete to be covered, and moisturizing conservation;
- Q:Basement cushion waterproof
- First, the basement moisture treatment structure is usually: first in the basement wall outer surface wiping 20mm thick 1: 2 waterproof mortar, basement walls should be used cement mortar masonry, gray seam must be full; and in the basement floor and the first Floor floor is divided into two walls of the level of moisture-proof layer. The outer wall of the basement wall should be tampered with the soil with poor permeability.
- Q:Basement floor mattress dry to what degree can do coil waterproof?
- Third, the membrane waterproof in the construction should first do the basement floor of the waterproof, and then the membrane along the basement floor continuous paste to the outer surface of the wall. Basement floor waterproofing first in the foundation pouring C10 concrete cushion, the thickness of about 100mm. And then paste the membrane, and then in the coil to wear 20 thick 1: 3 cement mortar, and finally pouring reinforced concrete floor. The outer surface of the wall first wip 20mm thick 1: 3 cement mortar, cold base oil, and then paste the membrane, the membrane should be stitched paste, adjacent coil lap width of not less than 100mm. The top of the coil should be higher than the maximum water level of about 500mm, the outer side of the brick wall.
- Q:Can the cushion on the prefabricated board floor be dug?
- Prefabricated board floor layer of cement layer is not called the cushion, should be called leveling layer, this layer can be removed, but be careful not to damage the prefabricated plate.
- Q:The roof cushion is waterproof on the slope roof
- Most of the slope roof itself is not waterproof. The role of the slope roof is used for drainage,
- Q:What is the waterproof layer and the waterproof cushion in the tile roof?
- Waterproof: In order to prevent rainwater from entering the roof, groundwater infiltrates the wall, the basement and the underground structures, and the indoor water penetrates the floor and the wall.
- Q:Large area ground concrete cushion seam Why is the separation of joints generally concrete
- Second, sub-grid seam set
In order to reduce the total shrinkage and temperature stress of the large area waterproof layer, avoid the leakage of the waterproof layer due to the deformation of the structural layer and the change of the temperature and humidity, the waterproof layer should be divided according to the shape, size and structure of the flat roof, Stay sewn. The waterproof layer is divided into several squares.
- Q:What is the difference between leveling and cushion?
- and only in the construction of the building at the bottom of the building, it is possible to use the relevant level of the cube, After the use of the underlying layer of the building, it is not exempt from the possibility of using leveling layer
- Q:Is the raft cushion waterproofing full of the cushion?
- As for the bottom of the bar thickness of the protective layer is generally 4cm, but if the basic floor of the concrete label is relatively high, the protective layer can be appropriately reduced.
- Q:Do you need a cushion on the ground floor?
- First to ask the use of your huts, there is the strength of the huts.
If you just get a little, then a few years into a dangerous floor, then calculate the ground, walls, roof (slope roof) area, doors and windows can be used as a wood plate loss.
LILAC produces PVC laminated coating (mesh fabric), covering cloth, soft ads fabrics, air tightness yacht cloth, trampoline cloth, swimming pool cloth, sun cloth, case mesh fabrics, mesh fabrics for building packaging, PVC ceiling soft membrane, air-filled toy membrane, floor surface membrane, etc., which sell well in hundreds of countries.
With warm attitude, we provide you with the best products and service. Welcome to visit and support us!
1. Manufacturer Overview
|Annual Output Value
||Above US$ 10 Million
||30% South America
20% Southeast Asia
10% Mid East
10% Eastern Asia
10% Central America
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||21% - 30%
|No.of Employees in Trade Department
||30,000-50,000 square meters
|No. of Production Lines
||OEM Service Offered; Design Service Offered
|Product Price Range