Q:My hard disk power cable was burned and when i connected my HD to another system, it is working....so what could be the problem in my pc???

Replace SATA power cable or using SATA Power from Power Supply. This issues will normally happen with separate piece of SATA Power Cable. Because of 4-pins power losing and touch another power pin. Lucky you. It didn't cook your hdd

Q:is there a cable for UPS where i can connect this kind of adapter?

You local should have the cable you need...

Q:I already have RCA cables. Just need to find a place that would sell the power cord.

you could either go to sony themselves or try a really good car audio shop and probably order you one and possibly try OKorder and see if they have one if you have halfords try them they are good for your different needs (if you have one ).

Q:There is currently a power cable going into the back of my primary sata hard drive but i want to put another hard drive in but there is not another power cable

I would try going to a nearby hardware store or electronics store that deals with computers and explain your situation to them. They can probably figure something out.

Q:I am getting a new gaming computer for Christmas with a 700 watt, 12.5 AMP (I think) power supply. I have two power cords for computers on my shelf, but my dad is worried that a standard power cable won't properly power my computer. Do I need to get a more powerful cable? If so, please send a link to where I can buy one, I have been searching but only found standard ones. Thank you.

A standard cord will work, that is not 7.5 amps it is 700w/115V=6.08amps. for 15 amps you need 14guage wire and for 20 amps 12 gauge 30 amps 10 gauge,and so on, you may need to be aware of how many other things you plug in to that circuit, such as a tv in another room or even another computer because you may have more than one room on the sam house circuit

Q:So I have this monitor that only has ONE port on it, which is a USB cable slot. Typically you would connect it to a laptop, and the USB cord also supplies it power at the same time display connection.

I have not seen or read from any source that RCA cable can be used for power. It is designed for audio connection and video connection only. The wire are not designed for use with electrical power connection, it will over heat and the wires will melt. Hope this will help you out.

Q:Okay so I'm production manager for a play in Oxford and I need to have a giant cardboard box drop from the ceiling triggered by an actor with a remote control on stage.I've found a rather nice electromagnet which should do the job which is triggered by a 9V battery. The trigger is an IR unit I'm building which finishes with a relay. The question is can I use a sound XLR cable as the wires in my circuit between the battery with the IR unit and the electromagnet?i.e.Electromagnet -----XLR-----gt; battery -------XLR-----gt; IR unitStandard XLR's do have 3 cables in and surely I only need 2 to complete the circuit.The only reason I'm thinking about using XLRs is that I'm not sure of the distance between things yet and I have plenty of XLRs in many different lengths.Any ideas?

I have used XLR cables for a lot of different purposes some are: Added a push button adapter to the end of a XLR so that a weather person could change weather graphics. Made RJ-11 telephone to XLR adapter for temporary telephone. Low power speaker cables. Even used them for mic cables. Belden 8412 is a thick rubber coated audio cable that is like a tank . . . it is hard to destroy you could short a 9 volt on the opposite end and not damage the cable. Use pins 23 for your project and if possible, connect pin 1 to an earth ground or common from your battery. Hope this helps. D.bumstead

Q:Now i get a message saying I have low system voltage. Is this gonna impair performance? Are there adapters for this?This is for a DESKTOP. Dell XPS.

What? What are you saying? What processor uses a 10 pin power connector? You did 'say' CPU! (Central Processing Unit) Or do you mean the 20 pin ATX Motherboard connector? (AMD's use no power to processor connector. Intel Pentium 4 and UP, use a four pin power connector, from the power supply to the motherboard. (Mobo) Edit: Low System Voltage will start with causing weird things to happen. Then the computer motherboard power headers,(Connectors), will burn up. I suggest you turn this computer off, un-plug it, and email me.

Q:I CAN'T AFFORD A NEW POWER SUPPLY CABLE/ADAPTER AT THE MOMENT.CAN SOMEONE HELP ME PLEASE.

Handycam Camcorders do not draw power from USB. You need to purchase a replacement power supply cable. If you take the camcorder to a place like Best Buy or Radio Shack, you can likely get a new cable for very little money (although it won't be the official Sony cable).

Q:The inside of my computer has a modular power supply that did not come with enough cables, and I have a graphics card that requires two 6 pin connections to the power supply. Luckily, my power supply has just enough open slots. The problem is that I can't find a place to buy a simple 6 pin cable. It needs to be about a foot long to reach. Can someone please help me? I would prefer newegg if possible, but I searched there and I'm getting pretty frustrated.

Assuming that the power supply can power the card you need a molex to 6pin adapter. They sell them on newegg. You wont be able to buy a 6pin cable unless your power supply is modual meaning you can disconnect the wires from the PSU. Most power supply's you cant do this and the ones that do cost extra.