Q:I tried looking up the the model # and a couple of sites that would sell it but cant find any. Also the player is like 2 years old so hard to find anything about it.

What is the question here? Are you looking to buy a replacement power cable? One of the multi use ones would work fine, set it for 9 volts. The other important part is the current rating (amps or mA). What does the DVD player say it needs? Make sure the new power cord can supply at least that much. Voltage: try 9 first, if not work then try 10 or 11 or 12. No higher than 12. Current: the same number or higher than listed on the player.

Q:cable laid in the GI trays and temperature is 30 digree centigrade

There is no definite safe formulas for your cables because it depends on many factors like what conductor . what insulation, how many cores ,what is your load , where is your load and ambient temperature and so on. The best guidance will be from the particular manufacturer who would provide the tables under various conditions as above.

Q:keep in mind this is a 6 yr old machine, the old roms connected the old way, I don't even know the name of the old cables.....

that okorder /

Q:I have been given a Toshiba flat screen tv - the product type is 20VL44G however the power cable has been lost. Does anyone know where I can get a replacement from as I have Googled this and cannot find anything? I am in the UK, thank you all.

If the cable normally fits into a socket on the tv, then you need to describe the socket to us and measure it if possible.

Q:Power cable YJV22-8.7 / 15kv-3 * 300 what meaning

Power cable YJV22-8.7 / 15kv-3 * 300 Meaning: refers to the copper core XLPE insulated double steel tape armored PVC sheathed power cable, cable rated working voltage 8.7 / 15KV, cable for the three-core, single Conductor cross-sectional area of 300mm2. YJ: cross-linked polyethylene insulation V: PVC sheathed 22: steel tape armor 8.7 / 15KV: rated working voltage 8.7 / 15 kV 3 * 300 Specifications: YJV22-8.7 / 15kv-3 * : Three conductors, single cross section of 300 square feet.

Q:So I've had my laptop for about a year and a half now and I've gone through 4 power cables, 3 non-factory. What happens with each one is, I plug it in, the blue light surrounding the hole turns on, the end of the power cable that plugs into my laptop gets super hot and either melts the power cable, or when I plug the cable in, the light won't come on unless I have it in just right. This usually starts to happen between one and three months after I get a new cable. It's starting to go through them faster now, any ideas?

Get it repaired. There might be a short circuit inside the socket. It will ruin your computer if you dont act now. You will lose your laptop or spend more if the laptop itsel gets damaged.

Q:Hey! I bought a new sound system for my truck including 4 new speakers, a sub, a 5-channel amp, and I'm running all new wiring. So far I've got the 3 RCA cables ran, along with the blue remote turn-on wire along the right side of my truck. I plan to run the Power wire down the left side and then to my amp.I've heard that you put the power wire and RCA cables on different sides, which is what I've done, but is it ok for my speaker wires to be run beside or close to the power wire(4-gauge fyi)?For example, the right side speaker wires wont be near it, but the left side speaker wires will be...Will this cause any weird noise from my speakers?I don't have the names/etc of all my gear right in front of me, but if u rly need it, I will quot;add detailsfor you! Thanks!!

Well....That is determined by how colossal the amp is. An extension wire has either 2 or three wires inside of at someplace between sixteen and 12 gauge wire. You could twist the entire conductors together and be excellent up to about 40 amps with three 12 gauge wires. The quandary with amplifiers is current no longer voltage. The thicker the wire the more present it will handle. Most any wire you purchase is rated as a minimum 120V. Check what dimension fuse the amp requires, whether it is more than 30 to forty amps i would purchase the correct size single wire for the amp. Also, fuse the wire at the battery. Fire is just not our pal. :)

Q:I am not sure of the reason but when i plugged in the power cable there was a crackling sound only for a second and then it stopped. I remember a similar occurennce when i had a loose electrical circuit would this have done any harm to the computer.

You should always use a power outlet that has an on/off switch so that you can switch off the outlet prior to plugging into the device. Only after plugged in do you turn on the power outlet (always turn off the outlet prior to unplugging from the device). The crackling sound is electrical and can cause detrimental problems to a Pc, laptop or monitor (or other electrical product).

Q:And will it damage the PS2 it if I use it?

Google the voltage the PS2 used, and if the PS3's power cable voltage is the same as the PS2's power cable then it's all good. Hope that helps.

Q:Were can i get a power cable for a SNES I checked okorder and they say there discontinued.

Try okorder but I am in Canada.. they surely have something like that close to you, and they are free..good luck!