Ge Dehumidifier With Pump

Hot Products

FAQ

What shall I do if the heating indicator of the air dryer is not extinguished?
Manual lights or other conditions need to be turned off
What are the characteristics of a conduction dryer?
The surface temperature of the material can be from below freezing point (freeze drying) to 330 DEG C; it is easy to operate under pressure and inert atmosphere, and volatile solvent can be recycled
What are the methods of use of the dehumidifier?
Heating and dehumidification: heating the air and increasing its temperature results in a decrease in the relative humidity of the humid air. Its drawback is that it does not reduce the moisture content of the air.
What are the cautions in the use of dryers?
When you open the dryer, you can not lift the lid, and use the left hand to hold down the dryer, the right hand carefully push the lid slightly, and so cold air slowly into, you can completely push, the lid must be tilted on the table
When the automobile air conditioner is used, why is the dryer hot?
The dryer is mounted behind the condenser and the compressor compresses refrigerant to produce a high temperature, high pressure gas into the condenser. A semi fogging refrigerant, which is cooled by a condenser to about 70 degrees, enters the dryer. So the dryer is very hot and hot
What are the common breakdowns in the automotive dryer?
Air compressor dryer inlet condition is good, normal, but output "(1{) is extremely poor, then there are two causes, one is the desiccant moisture, oil, thus blocking off the impurities exceed the standard, the other is on the dryer outlet hole; a one-way valve 2 stuck, that dryer is very long time without maintenance, please put a" dry assembly removed, a complete system maintenance
What is the cause of the dryer blockage?
Dry filter "dirty block" is due to poor cooling system, so that the pipe wall peeling off
What is the principle of a spray dehumidifier?
When the temperature of the wet gas drops below the dew point, the steam condenses and reduces the humidity of the gas