Q:UCP208 is not the company's UCP208 installation size and aperture are equal?

Well, they're all the same. Most of them are the same except for SKF, which has a little bit of hole spacing

Q:Spherical bearings * Luoyang domestic spherical bearing holder is required?

1. wave cage: a rolling bearing cage consisting of one or two wavy ring-shaped parts.2. cage (window): the hole or opening on the cage to accommodate one or more rolls.

Q:Where there is SKF bearing samples

Sample this kind of thing, you can only go to their website to look up, outside is not there, and this should not have electronic version, should be all paper, and only contact their company to get this

Q:Bearing is sliding bearing

Not necessarily. The rolling bearing also has a bearing seat!

Q:I want to know its detailed model, size and national standardIt says "WM" and the other end reads "FL203". The two center hole size is 80, and the maximum size at both ends is 100Note to find the bearing seat

The brand is Kazuma I have FYH, you can check the catalog. There are many models available.

Q:Spherical ball bearings and spherical bearings have what different

Bearing outer diameter: 51.6Bearing thickness: 165Bearing brand: NTN bearing2UCFC210 bearing application editorThese bearings can be used to: Appliance veterinary needle equipment, injection molding machine, pelletizing machine, textile equipment, auxiliary equipment, packaging machinery and equipment, raw materials, cotton wool processing equipment, cleaning machinery, treatment equipment, coking equipment, filling machine, dryer, aging furnace, burner accessories, plastic calendering machine equipment, bean products processing machinery parts, and so on.

Q:How should prevent spherical bearings eroded?

With a thin layer of grease in the cavity and the head cover, which plays the role of anti rust. Note that the grease in the cavity should not be smeared too much, otherwise it will affect heat dissipation and brake. Put the outer bearing on the axle neck, adjust the nut by hand, then tighten the adjusting nut with the axle wrench according to the required torque. After tightening the nut, turn a few turns to see the installation of the bearings; on the other hand, make the bearings match the race properly by turning. At this time, the bearings are tight and the wheels are free to rotate without feeling the axial clearance. Finally, the locking plate, the fixing nut, the tyre, the dust cover and the decorative cover are arranged in turn. Spherical bearings after adjustment, driving a mileage (about 10km), check for parking, wipe touch temperature, if fever, is caused by tight bearing adjustment, should be re adjusted, appropriate to relax the tension bearing.

Q:What are the best brands in the market? Thanks

KF or KFC: Kaifeng bearing factoryTR: Dongguan bearing factoryFK: Nanan Fujian bearing factory

Q:The best there is bearing other CAD drawings, thank you! You can send it to my email , thanks again

What about rolling seat bearings? To question again. A very complete set

Q:when inserted into the bearing hole, so that the top wire bearing on the top into the concave hole on the shaft?

There is no need to open the hole! A small platform is fine, too, if the location is not required! Otherwise, it is inconvenient to install the alignmentAskDoes it make sense that shafts with large torque apply?Chasing the answerIt's fine too！ The inner bore of the bearing is interference fit! The screws are tight enough!