High quality 1mm2 BV Copper Wire with a good price
- Ref Price:
-
- Loading Port:
- Qingdao
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 10000 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Item specifice
1mm2 BV Copper Wire
BV 1 single-core single-strand national standard wire
BV 1 mm square single core wire:refers to the copper core cross-sectional area is 1 square millimeter, copper core diameter is 1.13 mm.Home decoration 1 mm square single core wire used for lighting lines.There are many colors, according to the need to match.The lighting line is composed of two colors, that is phase line and zero line.Habitually "phase line" is red, "zero line" is blue.
Using 99.99% of the content of electrolytic copper and comply with the EU ROHS environmental protection directive of PVC with high quality manufacturing.
Product performance indicators are better than GB / T5023.3-2008 national standards.To ensure the safe choice of home safe electricity.
Recommended scope: used for the laying of lighting circuit.
Parameter
Product name: 1 mm2 single-core wire
Model: BV
Standard code: GB/T5023.3
Nominal cross section: 1 mm2
Conductor structure: 1/1.38mm
Rated voltage: 450/750V
Packing length: 100m
Characteristics
1. safe and durable
High-end cable, high quality, warranty for 50 years.
2. High purity copper
99.99% imports of oxygen-free copper, anti-aging, high conductivity, significantly reduce the line loss.
3. Environmental protection plastics
High-strength plastic insulation, new materials easy to heat, reduce resistance, fire waterproof and no leakage.
4. In strict accordance with national standards of production
National standards and integration of high-end cable production experience for many years, the quality is better than the national standard.
Introduction of our company
Our company is a professional China Wire and Cable Manufacturers, mainly supply Aerial bundled cable,House Electric Wire, Insulated Overhead Cable,Aluminium Conductor Steel Reinforced, PVC Control Cables,XLPE Power Cables,BV Electric Wires,Nylon Sheathed Cable,Buried Cable,High Voltage Cable,House Electric Wire,Single Core Flexible Copper Cable,Civil Wire And Cable etc. series of wire and cable products, sincerely welcome everyone to visit.
- Q:I would like to know what the standards are for Big Fat power leads being exposed, isn't that an OSHA hazard? What are all the volts, that need to be covered by a floor wire covers, so nobody will trip in them. Anyone know about this any helpful information regarding wiring safty on the job? Can a place be shut down for employee safty reasons? What are the major voltages in America? Honest and non- rude opinions Please Thank You
- Yupand I got a whole slew of hamsters to run my vehicle. Doesn't go too fast but it still gets me from point A to point B, which is usually just a couple miles. Water and hamster food is a heLL of a lot cheaper than petrol. No emissions other than, well, droppings. I wonder if that stuff is good fertilizer?
- Q:Basically I've got 1 ceiling light in the hallway but I want two. How do I split the 3 wires from the Original light to get them to connect to the 2nd light. I have the relevant wire just no idea how to split
- The first thing you need is enough of an education about electricity and house wiring to do the work safely. Go to the local library and get a D I Y book on basic home wiring, read it and understand it before you go any further. This is a very basic undertaking but until you have more knowledge about electricity you are too dangerous to allow near the project.
- Q:I need help with simple electrical wiring, everything from where does the active and neutral go, in for example lights with a common, a loop, a one and a two. Possibly any links to EBook of useful websites. I am currently undergoing a pre-vocational course at tafe, just looking for a better understanding
- Pay attention in class and read the literature, that is much better than what I could put in a paragraph or two. If you have specific problems, then bring them up here or send email. .
- Q:I was measuring the electrical conductivity of certain wires at school in a lab in Amperes with an Avometer set on ''B'' and the results got:nichrome 0.2mm 1 Anichrome 0.4mm 0.8 ACopper 0.2mm 0.7 AIron 0.5mm 0.23 AAre those results right? And if so does that mean that the Iron wire has the best conductivity among those those indicated?
- Those are not conductivities, those are just currents in a wire at some voltage. Are they right? I'd need the voltage and the length. You have to calculate the conductivity. Here is the formula below. Calculate the resistance as R E/I. Calculate the cross-sectional area of the wire in m? from this A πr?, r is radius of wire in m Resistance of a wire in Ω R ρL/A ρ is resistivity of the material in Ω-m L is length in meters A is cross-sectional area in m? Then ρ RA/L conductivity is 1 / resistivity or conductivity L / RA
- Q:How to identify the quality of the wire is good or bad!
- You take the graphics card 6pin power supply, red are graphics cards, motherboard auxiliary power supply is black, 4pin or 4 +4 structure
- Q:I am installing a new light switch on the inside of an exterior wall in my walkout basement. Because of the floor joists and finished ceiling, the only way I can figure to get the wiring to that location is by punching it through to the outside and running it along the wall and over to the location of the switch. This run will be about 30ft long and go around one corner. My question is: Can I do this with bare UF (outdoor romex) wire? Or will the wire need to be installed in a conduit?
- You said circuit breakers. If more then one breaker is tripping you should call an electrician. If just one is tripping and you can turn off the main breaker, take the wire off the breaker and put it on another one. If it trips that one too, you have a short somewhere and should get help. If it doesn't trip that breaker then the you have a bad breaker. If you haven't worked with electricity before, don't even take the cover off the breaker box. Call someone that has.
- Q:i have to do all 20 chapters and I was wondering if there was a site where I could find all the answers for each chapter and not read the book?only relpy if you know of a site that could do that for methanks
- This is a VERY scary question! Please, post your full name and address so that I don't hire you by accident to do any electrical wiring in MY house!
- Q:Hello We have been running a room heater and humidifier from a bedroom wall electrical outlet for the last 4-5 months with no issue.2 days ago we noticed a burning/melting plastic smell when we ran the appliances for 10-15 mins. I checked the wall outlet after removing its cover and visually looks OK i.e. no blackening. I have not removed the actual sockets. Also, the appliances themselves seem to be OK i.e. no smell from them.Could the issue be in the wiring inside a wall? How to determine this? The smell seems to starts when we use this particular outlet only.If problem is not in outlet, then will the wall need to be broken into to determine the source of the problem? Is there a more sophisticated solution?What could have caused this sudden issue? A rodent? Water leakage thru the siding? Other ideas?Note that the circuit breakers have not tripped during this time to indicate overload etc.Thanks in advance for your opinions.Homeowner_ne
- Burning Smell From Electrical Outlet
- Q:Help mi fill in the blank1. Check electrical ___ and ____ for wear and tear and faulty wiring.2. Do not _____ sockets.3. Keep electrical appliances clean and in good ___ order, and have them serviced regularly.4.Never run cables ____ mats or carpets where you _____ see wear and tear.5. Never use water on class C or ____ fire.
- 1. Check electrical wires and extension cords and appliances for wear and tear and faulty wiring. 2. Do not stick your fingers (or anything not meant to have electricity run through them) in sockets. 3. Keep electrical appliances clean and in good working order, and have them serviced regularly. 4.Never run cables under mats or carpets where you can not see wear and tear. 5. Never use water on class C or electrical fire.
- Q:What is the maximum load of 2.5 square millimeters of wire?
- Cable bridge between the multi-layer installation control cable between not less than 0.2M, the power cable between not less than 0.3M, weak cable and power cable between not less than 0.5M, if the shield can be reduced to 0.3M, the upper part of the bridge from the roof or other obstacles Not less than 0.3M different voltage for different purposes of the cable should not be laid in the same layer of the bridge if the conditions are limited to laying in the same layer of the bridge, the middle need to add partitions.
1. Manufacturer Overview |
|
|---|---|
| Location | |
| Year Established | |
| Annual Output Value | |
| Main Markets | |
| Company Certifications | |
2. Manufacturer Certificates |
|
|---|---|
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period | |
3. Manufacturer Capability |
|
|---|---|
| a)Trade Capacity | |
| Nearest Port | |
| Export Percentage | |
| No.of Employees in Trade Department | |
| Language Spoken: | |
| b)Factory Information | |
| Factory Size: | |
| No. of Production Lines | |
| Contract Manufacturing | |
| Product Price Range | |
Send your message to us
High quality 1mm2 BV Copper Wire with a good price
- Ref Price:
-
- Loading Port:
- Qingdao
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 10000 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
