Voltages Up to 35kv pvc Power Cable

Ref Price:
Loading Port:
China main port
Payment Terms:
TT or LC
Min Order Qty:
1000 m
Supply Capability:
20000 m/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Voltages  Up  to  35kv  pvc  Power  Cable

 

Brief Introduction

PVC/XLPE power cable is used to transmit and distribute power in power transmission and distribution system of 35kV or lower. It is generally applied to the fields including power, construction, mines, metallurgy, petrochemical industry and communication in complete replace of oil immersed paper insulated power cable and in partial replace of PVC insulated power cable.

 

Properties of  PVC Power Cable

 

1.The long-time permissible working temperature of cable conductive core is not more than 70 degrees.

 

2.During short circuit (max permanent time is not more than 5 seconds), the max temperature of cable conductor is not more than 165°C.
3.The difference level of laying cable is not restricted.When laying the cable,ambient temperature is not lower than 0°C.
4.They have good chemical stability,and properties of acid resistance,alkali resistance,salt resistance,oil resistance,solvent resistance and flame resistance.

 

 

Properties of XLPE Power Cable

1.The highest allowed operating temperature of conductor for long-term working is 90 degrees.

2.In short circuit (Max long term is no more than 5 seconds). The highest temperature for conductor is no more than 250 degrees.

3.The cable is laid without horizontal drop limit. The environment temperature should be no lower than 0 when lay. Otherwise it should be preheated.

4.Excellent electrical performance, resistance to chemical corrosion.

5.Can stand advisable traction when laid.Can stand traction from Outside.Left low smoke halogen-free after burned.Retard the burning of the cable.

 


Picture

 

 

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:how to run amp power cable from trunk to battery?
think of exterior the container. actually. you do no longer could desire to bypass for the period of the passenger compartment...you could run the wires below the automobile. only be valuable to tie them up nicely. stable success.
Q:Ask you a question: how the computer CD-ROM power supply 5V and 12V two lines? Another audio and video cable which group?
Cable can be parallel with the 10kV power cable laying, there is no distance requirements, two cables walking in a metal bridge is no problem. Fiber optic cable is through the optical communication, the power line of electromagnetic waves will not have an impact on it, there is no problem of electrical corrosion, because the cable is protected by an outer sheath. Now in the high-voltage cable directly attached to the internal fiber and power supply and communication, but also in the high-voltage overhead lines directly on the composite fiber (OPGW), while the power supply and power grid communication. Fiber optic cable, is a certain number of fiber in accordance with a certain way to form a cable core, outsourcing jacket, and some also cover the outer cover, used to achieve optical signal transmission of a communication line. Generally consists of cable core, reinforced steel wire, filler and jacket and other parts of the composition, as well as the need for waterproof layer, buffer layer, insulated metal wire and other components.
Q:how much will a xbox360 power cable go for, and the tv wire to connect the xbox and tv.seprate prices please?
If you mean the Power Supply Brick AC Adapter and cable and the Audio-Video cable, you should really sell them as a lot. On OKorder the two combined usually go from $20-30 with free priority mail shipping. If you are really intent on selling them separate you should expect around $10 for the Power Supply and around $5.00 for the AV Cable. Never say never, but you will NEVER get $50 for those items.
Q:I want to put a switch in a power cable heading to USB Hub?
Before you attempt this, make sure you have the following items: -Wire strippers -Electrical tape -Two terminal switch -Scissors IMPORTANT! make sure that the cable is unplugged from the computer and the hub before you do this! 1st, cut the cord halfway with the scissors. Next, remove the outer wire insulation from the two new ends you just cut with the wire strippers. Now strip the small colored wires that are now exposed. Then connect the red wire from one half of the cord to a terminal on the switch. Do the same with the other red wire from the other half of the cord and connect it to the other terminal on the switch. Strip the other small wires and connect them back to their appropriate colored wire. Finally, wrap each wire individually with electrical tape, then wrap the entire gap in the cord with it. Now plug the cord in and try it out!
Q:ATX 20+4 pin main power cable IMPORTANT?
The problem is with your SMPS (as much I know about computers). SMPS is Switched Mode Power Supply. It is the thing which supplies different power to different components of a computer. If your computer is not getting any power supply, that simply means your SMPS fails to draw current for your devices. You should either repair it or get a new one....
Q:Where can I find a 4 Pin Fan Power Splitter Cable in hamilton Ontario?
Before hooking that up, check the specs on your motherboard to see if that fan header will support loads from both fans. You may need to get a Molex to 4-pin converter and power directly off your power supply.
Q:PSU Cable for Computer?
(link defaults to 1foot, but id recommend a 6foot cable at the minimum, as 1-3 feet can be very limiting.) If using more then 1000W of power, you will need a cable capiable of it. one above is rated at 10A, and given psu efficiency (rounding way down for very inefficient ones) you should be able to get like 900-1000W+ from it w/o any worry. (that doesnt mean using a 1000W psu.. im talking about pulling 1000W+ from the wall, and unless you have like 3 gtx titans running at 100% .)
Q:Lawn mower power cable cut - mowing?
If you do not have an RCD cut out and were holding the plastic grip you were lucky, they are designed for this event but I always plug into a trip switch.
Q:Do ferrite beads on audio leads and power cables do anything meaning full?
Generally they are fitted to fix a narrow bandwidth issue, so you would need to know what interference issue you are trying to fix. In most coaxial application this is for the roll off between shielding types.
Q:Need Help Finding Alternator Power Cable?
usually only power wires run to the alternator, most arent grounded by a wire, they are grounded through their case and the mounting brakets to the engine, but all charging systems are a little different. I see your ground runs to the mounting bolt, and so that wire that goes to the mounting bolt on the alternator would be your ground wire to the battery. the large wire on the back of the alternator in your picture has BAT beside it, that is the wire that would be the power wire back out to the battery. i would suggest to get a haynes or chilton manual for this specific vehicle if your not sure of things such as this.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range