Q:Home basin faucet leaked, the arrow in the figure to see how to repair ah

Such as when the faucet dry glass glue, so completely dry and then use, but not a long way

Q:Kitchen pots hot and cold faucet water hose connector how to unscrew? Nuts in the deeper position of the valve body, wrenches and stretch does not go, hand screw is not OK, too tight. Is the faucet with the hose connection joints, can only cut? Leading water leakage to change it. What tools are there?

First connect the hose and the angle valve with a wrench. And then move the handle in turn, that is, to screw the direction of rotation, this is the faucet below the nut will be loose, holding a rag, into the pool below, touch the faucet nut, remove the nut, then faucet The whole to open to the.

Q:What is the size of the faucet?

General household faucets are 4 points, 6 points (inch size). That is the nominal 15,20 (mm). Indicates the diameter of the nozzle.

Q:Three-hole basin and single-hole basin can be installed single hole faucet it

Can be three holes in the installation of a single hole when you can go to OKorder to buy a rectangular decorative cover can cover the left and right to cover the hole on the exposed hole so that the installation of a single hole faucet up is beautiful!

Q:What is the faucet in the basin?

Head tied to the lower part of the gap leakage reasons: it is because the gland within the triangular gasket caused by wear. You can loosen the screw to remove the tie head, then remove the gland, and then remove the inside of the gland inside the triangle seal, put on a new one.

Q:Bathroom faucet good? Or pull the faucet good?

If you like to wash your hair and separate the bath, wash your hair in the basin, you can install a shower with a shower basin faucet, wash your hair, you can also wash the table. If you do not have this habit, the general can be the faucet, because the pull-type life will be shorter, easy to bad.

Q:how can i change the kitchen faucet and sprayer?

'Wired has it right, but forgot: Measure the 'hole pattern' in your existing sink/countertop and be sure that the replacement you buy has the same pattern. There are different numbers and spacings of those holes. It's maybe a two hour job for an experienced plumber. You should be able to do it in less than a day.

Q:Three hole wash basin put a single hole faucet, the remaining two holes how to plug on?

Can be decorated with a faucet dedicated panel.

Q:Which basin pot faucet is easy to use?

Germany only treasure series, the tap is basically used in this brand, very good.

Q:I've recently seen two movies where they show a sink with two faucets. One on each end of the basin. I'd never seen such a thing. Is one hot and one cold or what? Isn't that a little inconvenient if you want warm?

yeah in the older days they used to have a pipe that went to each tap and one was cold and one was hot but i do agree with you if they wanted warm water it would be weird if it was like it now so we are pretty lucky because we have the one tap so we can make warm water easy and it looks better with only one tap!