Kzqw22A Controller

Hot Products

LED Bluetooth Controller RGB Controller RGBW Controller

FAQ

Can the power be put together to adjust the light

Can't. The output voltage is constant and cannot load the dimmer. Suggest telephone contact repair personnel to repair

What are the characteristics of leds

Phase 2, after the cut (RPC) MOS tubes that move light 3, 1-10 VDC, cutting edge cutting phase control dimmer power: cutting edge dimming is USES the silicon controlled rectifier circuit, since communication phase 0, the input voltage chopper, until the thyristor turn-on, the input voltage. The principle is to adjust the waveform of each half wave of alternating current, to change the effective value of alternating current, to realize the purpose of adjusting the light. The advanced optical instrument has the advantages of high adjustment precision, high efficiency, small volume, light weight and easy remote control, so it is called the thyristor dimming.

Can leds be dimmed directly with smart dimming panels?

No, LED will be adjusted in its drive circuit.No, not only can you not adjust the light, but you can also damage the LED.

110V light LED lamp (tube lamp), how to match better

Transformers can only be like this! What is the method of modulation of the 110V LED light? It might be easier to change the light portion directly.

The difference between a thyristor dimmer and a PWM dimmer?

PWM to make out a light one on the damage to the eyes, the movie is 24 images per second, when less than this value, the eyes can distinguish between light and shade, old fluorescent lamp inferior often feel tired, to find the time to read it is 50 hz, when more than 100 hz, will reduce a lot of damage to people. The connection method is basically correct. But the power supply is the output of two lines.

What is the principle of led light, and what kind of modulation is commonly used?

In this case, the DIM105 is just a silicon-controlled tuner, not a switch source; Power Supply, which does not have the ability to control silicon, only provides Power, and DIM105 USES DIM105. Most of the thyristor is integrated in Power Supply with DIM105

Now, there are several leds. What principles do they use

1-10 v dimming device has two independent circuit, for a common voltage circuit, used to switch on or off to the power of the lighting equipment, the other one is low voltage circuit, which provides a reference voltage, tell lighting dimming level, 0 to 10 v dimming controller used for fluorescent lamp dimming control on before, now, because on the LED driver module and the constant power supply, and have a special control circuit, so the 0 to 10 v dimmer can also support a large number of LED light. But the disadvantages are also obvious, and the low voltage control signal requires an extra set of lines, which greatly improves the construction requirements.

Silicon-controlled incandescent lamp principle.

One way to control silicon is only positive half waveguide, which is equivalent to diode, and the actual power consumption of incandescent lamp is 1/4. It's 1/8 when the Angle is 90 degrees. Both sides of the two sides are able to guide the positive and negative half wave, and the actual end of the incandescent lamp is full voltage, and the power consumption is one. The positive and negative half waveguide angles are 1/4 for all 90 degrees.