Hydraulic Hose Rack

Hot Products

High Pressure Rubber Fuel Hose High Temperature One Steel Layer

PVC-U or UPVC low pressure water irrigation pipe

PVC-U electrical insulation conduits and fitting in buildings

dn110-1200mm PVC-UH sewage, drainage pvc-uh pipe

0.4MPa dn20-1600 HDPE80 Water supply Pipe

High Pressure Rubber Air Hose High Temperature for Autoparts

Polyethylene raised temperature resistance (PE-RT) for floor heating

High-performance hard polyvinyl chloride (PVC-UH) water supply pipe

Garden Water Rubber Hose Good Quality 5''

Rubber Air Hose Flexiable Made of EPDM High Pressure

FAQ

What happened to the soft rubber flat?

The two above are all correct, this is mainly to see where you are used, and if used in the settlement of the joint or expansion of the above, and then appear flat, then it is easy to burst the tube. It is important to note that metal bonding is recommended. Rubber joint is commonly used to shock, is not recommended when the expansion joints, expansion joints when used, if appear flat phenomenon, prone to pull off the situation (is flange off). The danger of exploding pipes everywhere. So it's not that rubber joints are bad, and it depends on where they are used.

Method for connecting glass tube and rubber tube

Just one end of the glass, wet with water, and then rotate hard

How can the rubber tube be used properly and how to use it properly?

Hose selection and installation caused by improper hose rupture. When replacing the hose, the hose wire length, number, shape and size of the joint should be reasonable, and should try to reduce the degree of bending in the hose; tighten union nut, do not make the hose distorted, excessive bending and twisting will reduce the service life of the hose greatly; some easily friction parts should take protective measures to prevent the hose due to wear and burst.

Hydraulic hose joint configuration

Gas safety hose joint: a joint security guarantee gas transmission, including metal hose, Baotou, connecting pipe and a connecting nut, one end of the connecting pipe and hose, metal hoop pressure Baotou into one, the other end is connected with the inner hole of flange nut for different aperture of two parts, large hole diameter is slightly larger than the connection the flange is provided with internal thread, big hole depth is larger than the thickness of flange, hole diameter is slightly larger than the connecting pipe outer diameter and smaller than the outside diameter of the flange.

The main features of Linatex rubber tube or what are the characteristics?

Linatrile: silicone reinforced rubber. It has the properties of wear resistance, oil resistance, aging resistance, fatigue resistance and good air tightness.Linard HD: carbon black / silica reinforced natural / synthetic rubber, hardness 60-70IRHD. With abrasion resistance, high resilience, cutting resistance, tear resistance, impact resistance and so on.

Do the rubber joint and Y filter need flange connection?

Not always。 There are 3 kinds of joint for rubber flexible joint. The most common and extensive use is flanged and threaded connection with the clamp connection. These 2 are based on the use of, and use less. The Y filters are flanged. Under special circumstances, can be customized according to demand drawings.

The basic buret is a rubber tube is inlaid with a glass bead to replace glass piston. Why this burets cannot be used to install Potassium Permanganate solution?

It can not be installed, but it does not conform to the standard of chemical experiment operation. Strong oxidizer will damage rubber tube. That's why it's not recommended. Acid burette operating standards have placed solution requirements.

Why can the air conditioning connection be made of copper tube? How about rubber tube and aluminium pipe? Please heroes pointing for the dishes.

Rubber tube pressure tube not Yi Nai, welding pressure is relatively low.