XLPE Insulated PVC Sheathed Control Cable
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product Introduction:
XLPE insulated control cable is suitable for A.C 50Hz control loop rated voltage up to 0.6/1kV in power plants、transformer substations、factories and petrochemical factories, using as the connecting wires between automatic applications and meters. It transfers electricity and make the whole electric system run safely and steadily.
Characteristics
1、It has good cold resistance、acid resistance、alkali resistance and could be used as organic solvent.
2、It has good performance in bending and has compact structure.
3、The insulation has good ventilation ability, so the overloading capacity for current
Specification:
Types | Designation | Standards |
KYJV | Copper conductor XLPE insulated PVC sheathed control cable | Q/321023KLA18 |
KYJVR | Copper conductor XLPE insulated PVC sheathed soft control cable | |
KYJVP | Copper conductor XLPE insulated PVC sheathed braid shielded control cable | |
KYJVRP | Copper conductor XLPE insulated PVC sheathed braid shielded soft control cable | |
KYJVP2 | Copper conductor XLPE insulated PVC sheathed copper tape shielded control cable | |
KYJV22 | Copper conductor XLPE insulated PVC sheathed steel tape armored control cable |
Specifications
Type | Rated voltage kV | Nominal core cross section mm2 | |||||||
0.75 | 1.0 | 1.5 | 2.5 | 4 | 6 | 10 | |||
Number of core | |||||||||
KYJV KYJVP | 0.6/1 | 2～61 | 2～14 | 2～10 | |||||
KYJVP2 | 4～61 | 4～14 | 4～10 | ||||||
KYJVR | 4～61 | — | — | ||||||
KYJVRP | 4～61 | 4～48 | — | — | |||||
KYJV22 | 7～61 | 4～61 | 4～14 | 4～10 | |||||
- Q: I bought a ATI HD2600 Pro Video card todayHere is the list of what my computer specs,Pentium 4 2.53 GHzCurrent Videocard - Rage Fury Pro 2000 Pro (Microsoft Corp)slot - AGP 8xmotherboard - BCS PT800CE - Aram - 512MB PC2700 333 MHZ (2 of them) 1G ramMonitor - 19ViewSonic VA902B 1280 x 1024im not sure about my battery wattage is enough for the card or not. it says 400+ battery supply is recommended, could it be the reason?when i plugged in my monitor cable to the adaptor for dvi to AGP and connect it to my video card, HD2600 Pro. I turn the computer on, but the monitor do not turn on. it just stays as it was. i have made sure that the monitor is on and all the plugs are right i do not understand what happen. BTW, when i try to check my bios settings, i am able to access it after putting in my password, but it won't let me update, everything is in blue, except some are quot;press enterto allow me to see the details. why is that? please help me...please please.
- it might if so the plugin looks like a floppy drive plug four pins if you got the card new and it has an adaptor you will have to use it most ati cards that have external power syncronize with the hard drive .
- Q: My brother lost the cable from the wall to the back of the power supply for his dell somehow, and I have one for a different brand (gateway). Are the cables themselves an interchangeable industry standard?
- Desktops...yes. Laptops...no.
- Q: I've got a 1994 Mitsubishi Eclipse GS 1.8 and I can't find any place to put the amp cable through the firewall! Any tips would be greatly appreciated. Thanks ;).
- Just adding to the grommet guys answer above: Just as important as the grommet; a fuse. You must have a fuse as close to the positive battery terminal as possible. Why?, you say? If, for whatever reason your power wire shorts out to the frame somewhere between your battery and your amp, what's going to prevent that wire from turning into a giant heating coil running the length of your car, and torching it. I've seen it first hand many times. And, no, the fuse at the amplifier, the fuse in the distribution block (if you're using one) or any other fuse other than a fuse at the battery won't do a thing for you power wire unless it's before the potential short. Like at the batttery... In short, the grommet prevents the short at the firewall. The fuse protects it in case it does it anyway.
- Q: Hi,I have a second-hand Antec NeoHE 550 power supply and I'd like to find a cable for it. I can't seem to find it on the Internet though.The cable is pictured here (the second from the left)On one end it has a 6-pin PSU connector and on the other end, it's a *female* 4-pin Molex connector. It is not a PCI-E cable.I'd like to know where I can buy one, I don't even know what to look for on Google.Thanks a lot!
- Cable thickness is there for a reason. The extra contemporary something makes use of, the thicker the cable. i'm beneficial you ought to probably replace the cable with the different cable, yet a smaller cable will warmth up extra truly, rather if compressed in with many cables in a cable administration device. you probably can, yet should you??
- Q: at the end of power cable are 2 wires
- I don't know what you mean by 302cm power cable. When it has 2 wires, one if usually the hot (power) and one is the ground (earth.) I don't know much else that'll help you, sorry.
- Q: I'd like to know what type of wire/specs. for a 3 phase high power cable that can handle a 41.6KVa that will be buried under the ground? The voltage will be a 220 volts in 60 Hz. could you show me how to calculate or any charts are really appreciated.
- 220V is phase voltage. Then line voltage will be 3^-2 *220 =381V.The current will be 63A.(41.6/3*220 ).The specification of cable is 3phase 4wire 400V. 50mm^2(if aluminum) or 25mm^2(copper) UG cable . If neutral wire is not required, cable will be 3 wire type.
- Q: What is the cable bucket in the power cable installation project?
- The width of the cable bridge international standard: cable bridge width ≤ 150 ~ 1.0150 <cable bridge width ≤ 300 ~ 1.2300 <cable bridge width ≤ 500 ~ 1.5500 <cable bridge width ≤ 800 ~ 2.0 cable bridge width> 800 ~ 2.2
- Q: I need help asap before I lose my patience with my dog.
- Try Radio Shack or if it has a 3 prong socket any computer power cable will work.
- Q: I recently bought a 750watt power inverter and there are two small cables to connect to it that look like small jumper cables. Can i connect my regular (longer/bigger) jumper cables to the car battery and connect the other end to the inverter cables??Ive been told that this will blow the inverter, and i've been told otherwise. Please let me know if you've had any experience doing this.Thanks,
- You'll be fine as long as you don't cross the cables- red to positive, black to negative. If you cross them you'll blow a fuse, or the inverter... Oh, and don't let the cables touch, they'll short out
- Q: One of my ottocinclus is munching on a little brown algae that's on the aquarium heater's power cable. Not dangerous, I guess? I don't think they can actually bite through it and expose the wire...?
- No problem, it's just scraping the algae off. Might get though the cable itself in couple of 100 years or so, so nothing to worry about. Ian
Send your message to us
XLPE Insulated PVC Sheathed Control Cable
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
