Shanghai factory BVVB flat cable instruments and meters, power cable
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 300 m
- Supply Capability:
- 300 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Specifications: BVVB
Voltage levels: 300/500 v
Execution standard: JB/T8734-2012
Scope of application: this product is used ac rated voltage up to and including 450/750 (U0 / U) power, electrical appliances, instrumentation and telecommunications equipment.
Using features: 1, the cable of rated voltage U0 / U for 300/500 v. 2, long-term allowed working temperature does not exceed 70 ℃. More than 3, short circuit temperature: cable or multicore cable short circuit occurs (the longest duration of no more than 5 s), the highest temperature conductor does not exceed 160 ℃. 4, installing a wire laying, bending radius should be greater than the specified value. Diameter greater than 25 mm above the wires, bending radius should not less than 6 times of cable diameter. Diameter is less than 25 mm below the wire, bending radius should not less than 4 times of wire diameter. 5, PVC insulated and sheathed wire and cable laying, environment temperature should not be below 0 ℃. 6, plastic insulated wire such as BV cloth when installing laying wires, if wear pipe laying, should give full consideration to the diameter of the plastic pipe size, pipe threading the total cross section should be not more than 40% of the plastic tube hole section, for the normal operation of electric wire have plenty of room cooling, installation and wire laying should be far away from heat source.
Key performance indicators: 1, the conductor when 20 ℃ maximum dc resistance, 24.5 Ω/km. 2, the ac voltage 2500 v, 5 minutes not breakdown.
- Q: Hi well I'm wondering if I can by those 8 pin 6 pin power cords what goes in to your graphics card to plug in to a power socket on the wall. Because I only have 500 wats and at the moment I have the 4850 and already I'm thinking about getting the GTx 295 or something can't remember. But it needs more then 500 wats lmao.I don't wont to upgrade my PSU so will I be able to plug the GTx in to the the wall like as a sprite power cable what goes in to the AC power cable in the wall?BTW I live in Australia so could could you tell me where you are like USA London ect just in case Australia doesn't have it. =)And where can I buy this transfer as well.
- You cannot plug it into the wall. Its too sophisticated. A single GTX 295 requires a 700-watt PSU with a 50 Amp 12v rail. Insane power consumption going on here. Upgradable to quad-SLI (woo). If you can afford a GTX why can't you afford the PSU? A PSU regulates your power and protects your equipment from voltage spikes etc. Get the PSU. Whats wrong with your 4850? can your board support a x-fire setup (two 4850s linked?) That'd be cheaper in the long run.
- Q: I had a power outage and I fixed it and now my cable wont work. The cable box is on it's just that there is no picture and not even the control can make it work. Can anyone figure out a way to help me with this?
- got mine fixed just took the power cable out and put it back in then it started up gl everyone.....
- Q: I just have the power cable for battery, lost the ground cable.. Can I cut from power cable and use for ground? Are they the same thing or different cables.??
- yes you could use the power cable for the ground because the power cable and ground cable are the same material, as long as both the same guage size is good to connect. For the ground should be as short as possible to the chassis of the car. ground cable just as important as power to get the circuit DC power circulation.
- Q: Does the ps4 and ps3 have the same power cable?
- Yes it does Adding to that, you need a TV with an hdmi port Also, the power cable doesn#x27;t come with a brick like the Xbox one does
- Q: trying to install garbage disposal and need it powered.I wanted to use this computer cable because the one that was with disposal got damaged.I would like to know how to determine which of the three (brown, blue, yellow) wires is ground. And for other two does it matter which way they are connected?Thanks in advance.
- STEP AWAY from the appliance. A computer draws a lot less than that motor you propose to connect. Don't be cheap. Get the proper size cord. What you show from the computer looks like #20. You want a 3 W. #16, cord.
- Q: i have a modular power supply i lost my cables moving out of my old house. so can any one tell me where i can get new ones to my power supply:
- I've never personally ordered any item specific parts but you should try NCIX . com
- Q: power cables of 630 mm buried (cable trench) what could be the reason for fire?
- a power surge can definitely cause a cable fire. but i believe insulation failure tops that, in buried cables in particular. and insulation failure is prompted more often with cables that come in direct contact with the earth, rather than those that may be run through piping, deterioting the insulation even faster. of course if the cable is damaged by digging, that could start a fire as well.
- Q: Ok so I was doing something stupid just now. Cuttiing a power cable that connects to the tv. Halfway through to cutting it, the wire explodes and hit my face o,o. So quickly, I turn all of the switches off and run to wash my face. I just wanted to know whether it's ok to turn all the switched back on cus I'm literally in the dark right now. And will there be any damage to my face since the wire explodes in my face?
- Everything will be fine to turn the switches back on, but you must unplug the cord you were cutting first. If not, you'll hear another loud pop as the breaker switches off. Unplug the cord, then turn the switches back on. Before you plug the tv in, check the cord going to it for burn or charring. If you do not see any, then stand to the side of the tv away from the screen and back, and then plug it in. Be careful. Unplug the cut cord first!!!
- Q: I just finished building my shed, I put a 1 1/2 inch conduit under the shed coming up into the corner. I am now about to dig the 65 foot trench back to the house. I need to run power, not a problem. I want to run a phone line, a network cable, and a cable wire for my satellite. I say shed but it is 12 by 20 feet with an attic. Can I run these additional lines in with the power. I was thinking about using a run of Shielded cables for the network and one for the phone. For the cable some heavy duty quot;I don't know what thoughquot;. Will the power lines mess the data up on them? What will work for the three if any. If I need to I could run them in a new conduit, but that is not cheap!
- Run the conduit all the way to the house, put the LV cables in it, Run the power in a separate metal conduit. If you do not wish to do it this way, dig a second ditch at least 3 feet deep and at least 4 feet away to separate the cable types. If they are close to each other, the power will induce a signal on the LV cables that will be a nuisance at least. If they must be close, have them cross at right angles.
- Q: why use of black color for electrical Power cables ?
- coz some materials are added for better quality and durability like carbon black which protects from UV radiation. -----------------
Send your message to us
Shanghai factory BVVB flat cable instruments and meters, power cable
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 300 m
- Supply Capability:
- 300 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords