Product Description:
Features:
Universal Input range: 100V-240VAC
Screw terminal housing
Dimming controlled at secondary by 1-10V VR
AC-DC Dimmable LED Driver
I/P:100-240V 50/60Hz
0-10v/1-10v electronic potrntinmeter
CE approval
Dimension: 171*47.5*28.5 mm
Model No. | LD-CU7036-18D |
Input | Voltage Range (VAC) | 100V-240Vac ± 6% |
Frequency Range (Hz) | 50 Hz / 60 Hz |
AC Current | 0.3A@115VAC / 0.15A@230VAC |
Max. Inrush Current | 12A |
Leakage Current | <1mA / 240 Vac |
Output | Voltage Range (VDC) | 9-36Vdc |
Rated Current Range (mA) | 0-700mA ± 6% |
Rated Power (W) | 9-25W Max |
Numbers of LEDs | 3-9pcs of 3W LEDs |
Dimming Control | (0-10V) 1-10V electronic potentiometer |
Protections | Over Load | 100~135% rated output power |
Flicker: Recovers aotomatically after fault condition has been removed. |
Environment | Ambient Temp. | -10°C~+50°C full load . |
Operating Humidity | 20% ~ 95% RH non-condensing. |
Storage Temp. / Humidity | -20 ~ +80°C / 10% ~ 95% RH |
Safety Approval | Safety Standards | CE |
- Q:1000 square meters low voltage.36 volts lighting power supply with multiple transformers and wires
- First of all, make sure your power is too large, but you are not recommended to do so, the cost is too high, the pressure drop is too large, you can raise the voltage to 220V or higher, and then transfer to avoid power losses. If the direct transmission, the power is slightly larger, the line will be very rough, the cost will be very high
- Q:Who knows how big transformers and lines the 36V transformer uses in lighting?
- The sectional area of the wire can be calculated according to the electric power formula. The current required by the wire is calculated, and then the reference to the national standard "500 volt copper core insulated wire, long term continuous load allowable ampacity meter" is selected.
- Q:Why should lighting transformers be used in factories and mines?
- There are two cases. One is the general factories and mines, and the low voltage is three-phase four wire system, and the neutral point is directly grounded. Between the phase line and the zero line is 220V, which can be connected with the illumination load.
- Q:How is the lighting power of the 380V transformer calculated?
- The transformer (Transformer) principle should change the AC voltage of the primary coil, the main component of the device level by using electromagnetic coil core (core) main functions: voltage transformation, current transformer, impedance converter, isolation, voltage regulator
- Q:Lighting, lights, transformers, bulb brightness is too low, what's the matter?
- If you share a power line, you must calculate the current and select the appropriate wire to ensure normal pressure drop and safe use.
- Q:How many A leakage protection switches are used in 5000VA lighting transformers?
- Secondary current =5000VA/220=22A, you can select the 32A leakage protection switch.
- Q:Why is elevator lighting transformer installed?
- 9.4.5 well distribution shall comply with the following requirements:1 the elevator hoistway shall be dedicated to the elevator, and no equipment, cables and other devices related to the lift shall be installed in the hoistway.2 the well shall be provided with illumination, and the illumination shall not be less than 501x, and shall comply with the following requirements:
- Q:How to calculate the rated capacity of small transformers for lighting purposes?
- In view of the power [kVA] conversion of each load, multiplied by the amount of consumption, according to the importance of the load, equipment location, voltage statistics, set the load line and load place of plastic case transformer capacity and its connection position. The future load power equipment shall be judged on the basis of prior installation or consideration of the economy in terms of equipment addition, installation, etc..
- Q:How many power illuminator can 5Kva 36V transformer drive?
- Transformer (Transformer) is a device that uses the principle of electromagnetic induction to change AC voltage. The main components are primary coil, secondary coil and iron core (magnetic core). The main functions are voltage conversion, current conversion, impedance transformation, isolation, voltage stabilization (magnetic saturation transformer) and so on. According to use can be divided into: power transformers and special transformers (electric furnace transformer, rectifier transformer, power frequency test transformer, voltage regulator, mine, variable audio transformers, intermediate frequency transformers, high frequency transformer, transformer, instrument transformer, the impact of electronic transformer, reactor, transformer etc.). Circuit symbols are often used as the beginning of numbers. Examples: T01, T201, T, etc..
- Q:Power and lighting transformers, lighting quality will be affected much?
- First look at this light. 24V100W, this specification is common in the headlights of large trucks, filled with inert gas, known as the small sun. Its power comes from a generator or battery, and is lit by alternating current or direct current.
We strive to be creative and responsive to our customers' needs, which in turn help strengthen our competitive advantage in the global marketplace.
We never stop pushing ourselves to be more professional and excellent.
1. Manufacturer Overview |
Location |
Guangdong,China (Mainland) |
Year Established |
2005 |
Annual Output Value |
|
Main Markets |
North America 0.36% South America 1.26% Eastern Europe 0.36% Western Europe 1.41% Central America 6.22% Northern Europe 0.36% Southern Europe 1.41% Domestic Market 88.62% |
Company Certifications |
TUV; Business License |
2. Manufacturer Certificates |
a) Certification Name |
|
Range |
|
Reference |
|
Validity Period |
|
3. Manufacturer Capability |
a)Trade Capacity |
|
Nearest Port |
|
Export Percentage |
|
No.of Employees in Trade Department |
|
Language Spoken: |
|
b)Factory Information |
|
Factory Size: |
3,000-5,000 square meters |
No. of Production Lines |
2 |
Contract Manufacturing |
OEM Service Offered Design Service Offered Buyer Label Offered |
Product Price Range |
|