Q:What kind of industrial repairs are used to make shafts and holes worn out?

5) the brake wheel occurs, the following conditions should be scrapped: 1.

Q:What does the brake drum have? How do you distinguish the brake drum or the brake disc?

The brake disc does not seem as easy to grip as the brake drum, so they provide better directional stability when parking. Unlike closed drum brakes, the brake disc is open, which has both advantages and disadvantages.

Q:Introduction of braking force distribution

EBD's full English name is Electronic Brake force Distribution, which is the electronic brake force distribution device.

Q:Which house does industrial brake do well?

they are in East China's ten largest industrial clutch and brake manufacturers

Q:Is the car brake good disc or drum?

And because of poor heat dissipation, a large amount of heat will be collected during braking. The brake block and drum are prone to complicated deformation under the influence of high temperature. The brake depression and chattering phenomenon are easy to occur, which results in the decrease of braking efficiency.

Q:What are the requirements for the construction and performance of brakes?

Special environment, according to specific customer requirements.

Q:The working principle of hydraulic brake

The excitation coil is connected to the rated voltage of the brake (DC), the electromagnetic force pull armature, the armature and the brake disc from the drive shaft (release), then with the brake disc or the normal operation started, when the transmission system of separation or power, brake also power, the spring pressure on the armature, the friction torque between the force the brake disc and armature and flange, the drive shaft fast stop

Q:What are the advantages of the anti lock braking device?

In recent years, because the automobile consumers pay more attention to the safety of most of the cars have the ABS as standard. If there is no ABS, emergency brake usually caused by tire locking, then sliding friction into rolling friction, braking force is greatly reduced. But if the front wheel locked, vehicle lost steering capability;

Q:The problem of reverse braking of direct current motor!!

the motor drive circuit controlled by single chip microcomputer needs to have power reverse connection function, for example, the bridge circuit composed of 4 transistors, or the positive and negative circuit composed by relay.

Q:The basic structure, working principle and main performance characteristics of the brake

In order to reduce the brake torque and brake structure size, usually installed in the high-speed shaft equipment, but for large equipment of high safety requirements (such as mine hoist, elevator etc.) should be installed near the equipment part of the work on the low-speed shaft.