Q:Open the cabinet factory how to choose edge machine, cutting saw and drill

If a large amount of orders, single variety, can choose electronic saws with the precise sliding table saw sawing with sheet material; choose edge sealing machine, automatic edge banding machine with full function; consider the option of four drill drill with double drill. This configuration has a high degree of automation, high productivity and fewer people, but a one-time investment will be greater.

Q:Can tiles be saw with a saw?

The use of ceramic tile cutting machine:1, positioningThe mobile ruler selected cutting size, with one hand holding the handle, the knife wheel to pull back, will be flat on the floor tile and tile cutting line is aligned with the bottom beam, the front floor tile depends on the gap of living.2, line upPut down the handle to make the cutter wheel in contact with the surface of the ceramic tile, the handle forward jog the cutter wheel in the surface of the ceramic tile cutting machine is a continuous uniform line.

Q:No problem what saw saw

Chainsaw saw the use and maintenance of chain saw chain before use, should be in the chain of oil thrown out before working, should soak in the oil bowl after work. In the work process should pay attention to the change of cutting debris, the sawtooth blunt is not sharp, application dedicated file trimming zigzag chain teeth, in order to ensure the correct method of sharp serrated, dressing is: contusion teeth along cutting direction, only toward the tooth direction and teeth, can not be pulled back, angle and file chainsaw chain angle is 30 degrees, the general assembly so that the chain saw chain more blunt, angle is too small, is caused by the chain saw chain is not durable, not sharp chain saw chain will increase the burden on the engine, causing incision burnt and clamping saw, the adverse impact on the chain saw guide plate.

Q:How do electronic saws operate?

1, after feeding, device program-controlled push plate device should not run too fast, program-controlled push plate device (for operators) speed greater than 25 meters / minute, will automatically close the push;2. The maximum pushing height of the programmable push plate is 80mm, and the overrun is prohibited;

Q:What type of saw blade is used to cut the fireproof board

Fireproof board is the impregnation process of base paper (titanium powder, paper and kraft paper) through melamine and phenolic resin, which is made by high temperature and high pressure. So in the sawing fire board is melamine board type, usually with a professional panel saw, saw blade for cutting board professional. Commonly used are two specifications of the saw blade, one is 12 inches, 72 teeth, one is 12 inches, 96 teeth of the saw blade, all choose flat teeth. With the use of the saw blade, so that it will not collapse, and the section is very smooth.

Q:Is the saw without teeth? Is it a kind of thing?

A toothless saw is used for cutting things. A corner grinder is used to polish surfaces or edges and corners.

Q:How to sort, file, cut, drill, cut, tap?

From the processing process, marking, filing, drilling, sawing, tapping, according to the bench process.Marking is the basis of operation and must be carried out first;After marking, the position of filing, cutting, drilling and sawing can be determined;

Q:What's the use of a steel saw?

Carpentry mainly uses it in the fine, multi turn artistic modelling, the writing, the pattern soaring.

Q:The prestressing tendon should be cut off by grinding wheel saw or cutting machine. Why can't arc cutting be adopted?

The reason is very simple, I do not say Theory: the temperature of welding is too high, so that steel annealing, and reduceStrength of reinforcement

Q:Reciprocating working principle of pneumatic reciprocating saw and the working principle of high frequency quiver used for cutting sponge.

There are two ways to control the compressed air. One is that the cylinder moves at the same time, it drives the gas path switch, and automatically switches to a certain position. The other is to set holes in the corresponding position of the cylinder. The compressed air shows the air hole after the piston is reached, and uses the compressed air derived from the air hole to drive the gas path switching.