Transformer Landscape Lighting

Hot Products

FAQ

In a bulb, the ambient temperature of the LED is LED, the temperature of the air in the bulb, or the temperature of the aluminum substrate
LED working environment temperature refers to the temperature of the air in the LED bulb, not the temperature of the aluminum substrate. The temperature of the aluminum substrate will rise as the LED lights up, and rise to a certain extent, which will involve the highest environmental temperature.
LED can the bulb be used in the bathroom?
Yes, the bulb may is waterproof and dustproof with protection
Want to buy a few LED bulb, do not know how to identify the quality of good or bad, ask for solution ~!
Plastic bulb lamp, I have done it myself, this gadget specializes in low-end market, it is recommended not to use, used well, used for a long time, used poorly, minutes of effort have to hang.
LED bulb is broken. The luminous patch is not bad. Can it be made into USB lamp?
Cannot connect directly. LED bulb is usually a series of LED series, and then parallel, generally about 12V. Single chip LED generally rated voltage at 3.0V~3.6V, USB, output voltage of about 5.0V.
Is it possible to manually weld LED bulb bulbs?
This is what you do very mature products, the most simple aging, is like this
Led what's the flash of the bulb?
So, this is the power overheating protection at work. It will not be the case if the outer shell is enlarged or the room is ventilated and the heat should be cooled.
What advantages does LED bulb replace energy saving lamp?
The response time is fast, the energy saving lamp is millisecond, and the LED light is nanosecond
LED bulb after the power failure, still glimmer, can last hours or even all day, what is the reason?!
If the switch is installed on the zero line, LED is the resistance capacitance step-down if the light shimmer is mainly the induction voltage capacitance inside (with the switch installed on the line Never mind, because there are capacitance induction voltage). The meter won't turn. Of course, you can not expect to use this induced voltage to lighting, because this voltage is extremely weak, unable to meet the minimum requirements for lighting. If the switch is on the zero line, and there is a problem with the capacitor in the capacitive circuit, it is likely to be a long time. Over time, the circuit in the LED light proved to be a problem