Q:Acting as pneumatic component 60I've been selling pneumatic parts for three years

Nowadays, there are too many brands of pneumatic components, such as low-end brands, the price must be competitive

Q:I've never touched this piece of pneumatic components. How do I get started?

3, expand the scope of knowledge, began to understand some of the market models, try to match simple pneumatic components, such as large cylinder, solenoid valve, and so on and so on.4, next is the accumulation of their knowledge, through work contact with their own learning, gradually know more, understand more and more deep, knowledge is more and more fine, this depends on time.

Q:In turn, the pneumatic components follow the inlet direction. Why?

The function and function of the pneumatic triplex is to purify the air source of the compressed air and then use it to the equipment. Pneumatic triplex according to the direction of intake are: oil filter (filter compressed air) - pressure reducing valve (to pass through the gas pressure drop) - oil mist (for oil atomization).

Q:What are the specific parts of pneumatic components?

Is it the aerodynamic suite, the regular car? There are front nose, side skirts around the body, rear wing, rear diffuser, chassis, diversion device, etc.

Q:I would like to ask you, pneumatic components, including what mechanical parts?

Pneumatic actuating element (cylinder), control element (solenoid valve)

Q:What are pneumatic components?Pneumatic components include:

The mechanical energy that converts compressed air pressure, reduced energy, and elastic energy into various kinetic energy.

Q:What are the similarities and differences between the pneumatic directional control valve and the hydraulic directional control valve?

Similarities and differences:(I) the energy used is differentPneumatic components and devices can use the air compressor station centralized gas supply method, according to the use requirements and control points to adjust the working pressure of each reducing valve. The hydraulic valve is provided with a return line to facilitate the collection of the hydraulic oil used by the tank. The pneumatic control valve can direct the compressed air to the atmosphere through the exhaust port.

Q:Why does the pneumatic element contain no copper and does not contain polytetrafluoroethylene?

Many of the pneumatic components are copper. Many of the liquid valves are made of copper. Many of the bearings of the cylinder are copper

Q:What elements are most common in pneumatic?

Pneumatic systems are generally, gas (two pieces, Sanlian and other air source processing), pneumatic control unit (electric control valve, pneumatic control valve, or mechanical control valve). Pneumatic execution unit (cylinder). A pneumatic system, these things basically have to have. Of course, the joint pipe is also essential

Q:Types of pneumatic Triplex Oil

Now most of the cylinder, valve generally in the pneumatic components of the pre sliding parts parts into the semi-solid grease like (or paste oil) called non oil components. Therefore, there is no need to provide oil mist lubrication in such pneumatic transmission. If the oil mist lubrication to non oil pneumatic components, not only has no meaning, and semi solid lubricating grease is very thin oil mist and oil slowly dilute the sealed gas loss is bad. If the oil has been supplied with oil mist, it should remain the same.