30 Mil Pvc Geomembrane

Hot Products

Road Construction Non-woven Geotextile

Reinforced Geomembrane

Spunbond Nonwoven Geotextile hydrolyzation and corrosion resistibility

Reinforced Geomembrane

PET Long Filament Nonwoven Geotextile

HDPE Geomembrane Waterproof Material

Geotextile Fabric

LLDPE Geomembrane

Long Fiber Nonwoven Geotextile

Polyester PET Filament Nonwoven Geotextile

FAQ

Why do the basics of the cushion waterproofing

As for the bottom of the bar thickness of the protective layer is generally 4cm, but if the basic floor of the concrete label is relatively high, the protective layer can be appropriately reduced.

Basement floor mattress dry to what degree can do coil waterproof?

Third, the membrane waterproof in the construction should first do the basement floor of the waterproof, and then the membrane along the basement floor continuous paste to the outer surface of the wall. Basement floor waterproofing first in the foundation pouring C10 concrete cushion, the thickness of about 100mm. And then paste the membrane, and then in the coil to wear 20 thick 1: 3 cement mortar, and finally pouring reinforced concrete floor. The outer surface of the wall first wip 20mm thick 1: 3 cement mortar, cold base oil, and then paste the membrane, the membrane should be stitched paste, adjacent coil lap width of not less than 100mm. The top of the coil should be higher than the maximum water level of about 500mm, the outer side of the brick wall.

Large area ground concrete cushion seam Why is the separation of joints generally concrete

Large area of ??concrete after concrete construction, the concrete volume will be slightly inflated, the ground for a long time deposition, will be sinking, all large area of ??concrete construction, the general set of separation joints.

Why calculate the amount of time to count a lot of cushion ah

In the building construction refers to the base is located below the cushion sometimes also served as grassroots. With the cushion, in the above work is convenient, clean, especially the mold, bar reinforced, pouring concrete and other processes, will not be affected by the basic earth pollution. Set the place where the cushion is generally based, floor, roof (slope) and so on.

The cushion is usually in the housing which parts

There was no other place in the house below

When the cushion is used, the thickness of the protective layer is not less than ()

Not on the roof: the general waterproof layer above can be used 15 ~ 25mm cement mortar protection.

The roof cushion is waterproof on the slope roof

When the moisture generated by the ice dam into the external walls of the gap, the walls and insulation layer will become damp, which is the ideal environment for the breeding of mold.

Basement cushion waterproof

First, the basement moisture treatment structure is usually: first in the basement wall outer surface wiping 20mm thick 1: 2 waterproof mortar, basement walls should be used cement mortar masonry, gray seam must be full; and in the basement floor and the first Floor floor is divided into two walls of the level of moisture-proof layer. The outer wall of the basement wall should be tampered with the soil with poor permeability.