Led Light Bulbs For Ceiling Fixtures
Led Light Bulbs For Ceiling Fixtures Related Searches
Led Bulbs For Can Lights High Bay Led Light Bulbs Led Bulb Ceiling Light Blue Led Pool Light Bulb Filament Light Bulbs Led Small Dimmable Led Bulbs T8 Led Replacement Bulbs Led E14/E27 Bulbs Indoor Flood Light Bulbs 10 Ft Fluorescent Light BulbsHot Searches
Led Light Bulbs For Ceiling Fixtures Supplier & Manufacturer from China
Okorder.com is a professional Led Light Bulbs For Ceiling Fixtures supplier & manufacturer, offers integrated one-stop services including real-time quoting and online cargo tracking. We are funded by CNBM Group, a Fortune 500 enterprise and the largest Led Light Bulbs For Ceiling Fixtures firm in China.Hot Products
FAQ
- The ten patch LED lights are connected in parallel. The rated power is 5 watts. How much voltage do you need?
- Shunt split current series split voltageIs your single lamp voltage rated voltageIn addition to the red and green LED lights, the voltage is between 2 and 2.4, and the other colors are 3 to 3.6V
- LED patches have several ways of welding. Which ones can be reflow? What can be done by eutectic welding? Is the welding of viscose and lens material is required?
- Of course, the reflow soldering is generally divided into three sections of six principle of oven temperature is 150 degrees, 190 degrees, 220 degrees, with a PC lens products can not reflow soldering, PC deformation at 150 degrees, can be heated by a soldering paste on the heating plate.
- What determines the brightness of the patch LED?
- Lamp brightness level itself, is also in the rated current situation, its brightness
- What is patch SMD-LED?
- Semiconductor wafers consist of two parts, one is P type semiconductor, in which the hole dominates, and the other end is N type semiconductor, which is mainly electronic here. But when the two semiconductors are connected, they form a P-N junction between them. When the current passes through the wire acting on the chip, the electrons are pushed into the P region. In the P region, electrons combine with the hole and then emit energy in the form of photons, which is the principle of LED luminescence. The wavelength of light, that is, the color of light, is determined by the material that forms the P-N junction.
- Patch LED market conditions
- With good market expectations for the future status of SMD LED, all the major manufacturers have launched their own SMD LED development planning and prototype products, all of a sudden, SMD LED market showing a flourishing and lively atmosphere of contention of a hundred schools of thought.
- What is the principle used in SMD LED lamp, should pay attention to what the problem?
- LED installation method 1, don't install the LED pin in 2, under the condition of deformation in printed circuit board when installing LED, circuit board hole center distance and LED pin center spacing should be the same, if the hole spacing will make the lamp feet have residual stress and welding...
- How many volts is a single LED on the LED patch band?
- 3V or so, generally three, a group plus a resistor, power supply with 12V
- SMD LED lamp working voltage?
- Single chip of 1 watts, more than a lot, different colors, the voltage will be different. White is usually 3.0-3.6V.* in addition to their working voltage, working current is more important parameters, once the flow, it will burn out.The LED lamp. With chips is variety, many tricks, they can be connected in series and parallel. The voltage is divided into high voltage, low voltage and medium voltage
