Q:What is the factor of the fuse tube?

In most cases, the delay fuse is best suited for circuit protection with pulses.

Q:What does the fuse HRC say?

while limiting the current through the current to less than the peak current.

Q:What material is used for the fuse

Fuse material is mainly made of low-melting alloy such as aluminum antimony alloy.

Q:Fuse fuse all the reasons

Fuse blown the essence: the current flows through the fuse heat, so that the fuse heat, if the heat can not be dispersed in time, the fuse continues to heat up to melt melting after the break.

Q:Why can not change the fuse when replacing the fuse

so that will not burn the electrical use of the fuse resistance and thickness is inversely proportional to if the thick fuse,

Q:What is a quick fuse:

As the semiconductor components of the overload capacity is very low

Q:The air switch is different from the fuse

Fast fuse fuse current is generally selected 1.5 to 2 times the load current, overcurrent 2 to 3 times can be quickly blown, and anti-time characteristics of steep, arc breaking ability, especially for power electronic device protection and DC circuit protection

Q:Fuse tube selection fuse factor

Rated current - In fuse rated current is its nominal rated current, usually the circuit can work long-term maximum current value.

Q:What happens to the fuse's melting point?

Of course, there are fuses can not be measured by temperature, but should be able to bear the number of security measure.

Q:Are there any resistance to the fuse?

Fuse blows and the principle is Joule's law